Euro-Pro VPW43 Getting To Know Your Pressure Washer, Operating Instructions, Motor Thermostat

GETTING TO KNOW YOUR PRESSURE WASHER

OPERATING INSTRUCTIONS

	15		16				9
8					11
			13		10
				14		12	7
1. Pressure Washer				12.	High Pressure Hose Connector
2.	Water Intake			13.	High Pressure Lance
3.	High Pressure Output			14.	Fan Jet Lance
4.	On/Off Switch			15.	Detergent Applicator Bottle
5.	Trolley			16.	Garden Hose Coupling
6.	Trolley Handle			17.	Handle Bracket
7.	High Pressure Hose			18.	Top Brace
8.	Rotary Brush			19.	Legs (x2)
9.	Trigger Gun			20.	Support Bracket
10.	Safety Lock			21.	Front Support
11.	Trigger			22.	#8 Phillips Screws 1/2–inch		(x4) (not shown)
				23.	#8 Phillips Screws 1-inch (x4) (not shown)
Illustrations may differ from actual product.
Technical Specifications
Voltage:		120V.,	60Hz.
Power:		12.5 Amps.
Pressure:		1450 psi. (max)
Flow Rate:		1.45 GpH

Motor Thermostat

Important: This pressure washer is equipped with a motor thermostat. The motor will stop if it is overheating. Wait 10-20 minutes before starting the unit again. If it stops again, please call EURO- PRO Operating LLC customer service at 1-800-798-7398.

Ground Fault Circuit

Interrupter (GFCI)

This unit is equipped with a Ground Fault Circuit Interrupter (GFCI) built into the plug. This device provides additional protection from the risk of electrical shock. When connecting the GFCI to the electrical outlet, the indicator should appear red. If the indicator is not red, depress the RESET button on the GFCI until the indicator appears red.

Cleaning Tips

Wood Decks: Rinse deck and surrounding area with fresh water. If using detergent, fill the detergent applicator bottle and apply to the area being cleaned. For optimal results, reduce your work area to small sections and clean each section one at a time. Allow the detergent to rest on the surface for a few minutes and then rinse at high pressure. Do not let the detergent dry on the deck. Always clean from left to right and top to bottom for best results. Rinse at high pressure using the fan jet keeping the tip of the spray nozzle 8-12 inches from the surface. Caution: For soft woods, increase the distance from the cleaning surface.

Cars, Boats, & Motorcycles: Wet down area to be cleaned before applying detergent with clean water. Fill the detergent applicator bottle and apply to the area being cleaned. To achieve best results, clean one side at a time. Allow the detergent to rest on the surface for a few minutes but do not let it dry. Rinse at high pressure using the fan jet in a sweeping motion keeping the tip of the spray nozzle at least 8-10 inches away from the surface. Maintain a further distance when using a direct spray. Wipe surface for a polished finish.

3

8