12.Pour a capful of bleach into the tubing connected in step 11 onto the 3/4” NPT x 3/4” barb connector at the surge tank ball valve and then immediately connect the loose tubing end to the 1/2” NPT x 3/4” barb connector installed in step 7. Fully tighten the remaining tubing clamp to secure the tubing onto the connector barb.

13.Place the high flow filter system into service by opening the inlet water ball valve. Open the surge tank ball valve and allow the surge tank to fill for three minutes.

14.Connect a hose to the high flow filter system activation valve connected to the plated cross. Close inlet valve to the highflow system. Open the flush valve and allow the water to drain to waste for five minutes in order to expel chlorinated water from the surge tank or until no chlorine odor is detected. Then close the flush valve and open the inlet valve to the high flow system. If new cartridges installed, flush high flow system for five minutes. The high flow filter system and surge tank is now in service.

15.Inspect the system for any water leakage, tightening all connections as required until no leakage is observed.

16.After installation of the surge tank, it will be necessary to close the surge tank ball valve prior to removing cartridges from the pre-filter or high flow filter system.

Before removing any filter cartridges always close the ball valve on the surge tank.

SERVICE

No routine servicing of the surge tank is required under normal operating conditions although periodic sanitizing (annual) is recommended. The only servicing of the surge tank occurs if the internal air bladder pressure (excluding water pressure) is not 20±2 psi when empty. A conventional tire valve is provided at the top of the extra capacity surge tank and near the bottom of the standard surge tank to monitor and adjust the internal pressure.

LIMITED WARRANTY

COMMERCIAL WATER TREATMENT EQUIPMENT

You have just purchased one of the finest water treatment units made. As an expression of our confidence in Everpure products, this product is warranted against defects in material and workmanship to the original end-user when installed in accordance with Everpure specifications. The warranty period commences from the date of purchase and is administered as follows:

For a period of ONE YEAR

Replaceable elements (i.e., filter & water treatment cartridges)*

For a period of FIVE YEARS

The entire system (excluding replaceable elements)

*This is for material & workmanship, not filter or water treatment cartridge life.

The unit must be used in operating conditions that conform to Everpure’s recommended design guidelines. This warranty will not apply if the unit has been modified, repaired or altered by someone not authorized by Everpure.

If a part described above is found defective within the specified period, you should notify Everpure technical service at the phone number listed below. Any part found defective within the terms of this warranty will be repaired or replaced (at Everpure’s discretion) by your local dealer or Everpure technical service. You pay only freight from our factory and local dealer charges. Any repaired or replaced warranty item will be incorporated under the original warranty terms of the existing system.

We are not responsible for damage caused by accident, fire, flood, freezing, Act of God, misuse, misapplication, neglect, oxidizing agents (such as chlorine, ozone, chloramines and other related components), alteration, installation or operation contrary to our printed instructions, or by the use of accessories or components which do not meet Everpure’s specifications. Refer to the specifications section in the Installation and Operating manual for approved application parameters.

Our product performance specifications are furnished with each water treatment unit. TO THE EXTENT PERMITTED BY LAW, EVERPURE DISCLAIMS ALL IMPLIED WARRANTIES, INCLUDING WITHOUT LIMITATION WARRANTIES OF MERCHANTABILITY AND FITNESS FOR PARTICULAR PURPOSE; TO THE EXTENT REQUIRED BY LAW, ANY SUCH IMPLIED WARRANTIES ARE LIMITED IN DURATION TO THE PERIOD SPECIFIED ABOVE FOR THE ENTIRE WATER TREATMENT UNIT. As a manufacturer, we do not know the characteristics of your water supply or the purpose for which you are purchasing this product. The quality of water supplies may vary seasonally or over a period of time, and your water usage rate may vary as well. Water characteristics can also differ considerably

if this product is moved to a new location. For these reasons, we assume no liability for the determination of the proper equipment necessary to meet your requirements, and we do not authorize others to assume such obligations for us. Further, we assume no liability and extend no warranties, express or implied, for the use of this product with a non-potable water source or a water source which does not meet the conditions for use described in the owner’s guide or performance data sheet for this product. OUR OBLIGATIONS UNDER THIS WARRANTY ARE LIMITED TO THE REPAIR OR REPLACEMENT (AT EVERPURE’S DISCRETION) OF THE FAILED PARTS OF THE WATER TREATMENT UNIT, AND WE ASSUME NO LIABILITY WHATSOEVER FOR DIRECT, INDIRECT, INCIDENTAL, CONSEQUENTIAL, SPECIAL, GENERAL OR OTHER DAMAGES.

Some states do not allow the exclusion of implied warranties or limitations on how long an implied warranty lasts, so the above limitation may not apply to you. Similarly, some states do not allow the exclusion of incidental or consequential damages, so the above limitation or exclusion may not apply to you. This warranty gives you specific legal rights, and you may also have other rights which vary from state to state. Consult your telephone directory for your local independently operated Everpure dealer, or write Everpure for warranty and service information.

For sales, replacement components, and service, contact your Everpure dealer or:

Technical Service

Everpure, LLC: 1040 Muirfield Drive • Hanover Park, Illinois 60133 • 800.323.7873

800.942.1153

In Europe: Toekomstlaan 30 • B-2200 Herentals, Belguim

www.everpure.com

In Japan: Hashimoto MN Bldg. 7F • 3-25-1 Hashimoto Sagamihara-Shi • Kanagawa 229-1103, Japan

 

Printed in U.S.A.

EV3100-91C FE05

Page 4
Image 4
Everpure EV9100-24, EV3098-41, EV3092-54, EV3097-09, EV9336-52 Limited Warranty, Commercial Water Treatment Equipment

EV3098-41, EV9108-40, EV3057-83, EV3099-62, EV9100-24 specifications

The Everpure brand is synonymous with premium water filtration systems that are ideal for both commercial and residential applications. Among its impressive lineup, models EV3047-10, EV9100-24, EV3034-83, EV3057-83, and EV3098-41 stand out due to their advanced features and cutting-edge technologies.

The EV3047-10 is designed specifically for high-flow applications, making it a top choice for restaurants and cafes. It utilizes a carbon-block filtration system that effectively removes chlorine taste and odor, sediment, and other impurities, ensuring the highest quality drinking water and ice. Its impressive flow rate significantly enhances efficiency, making it suitable for busy environments.

The EV9100-24 model is renowned for its innovative micro-filtration technology. It is capable of reducing cysts, bacteria, and other harmful contaminants, providing users with safe and clean water. This filter also features a scale reduction technology that helps protect equipment like espresso machines and ice makers from mineral buildup, ultimately extending their life and performance.

The Everpure EV3034-83 offers unique features tailored for fountain and beverage applications. It includes a patented pre-coat filtration system that removes particulates and contaminants effectively. This model's easy-change cartridge design makes maintenance a breeze, allowing for quick filter replacements without complicated procedures, which is vital for operations that require uninterrupted service.

Model EV3057-83 incorporates advanced filtration technology, delivering exceptional water quality for food service and coffee preparation. Its proprietary blend of filtration media targets impurities that affect taste and odor, ensuring a consistently great flavor in every cup or dish. Additionally, this model is equipped with a built-in scale inhibitor that protects appliances from the damaging effects of hard water, significantly reducing maintenance costs.

Lastly, the EV3098-41 is designed for heavy-duty applications, catering to businesses that demand high-capacity filtration. Utilizing the latest in filtration innovation, this model boasts a unique dual-stage system that provides advanced protection against contaminants while improving water clarity and taste. Its robust construction allows it to handle high volumes, making it an invaluable asset in busy commercial settings.

In summary, Everpure's EV3047-10, EV9100-24, EV3034-83, EV3057-83, and EV3098-41 models showcase the brand's commitment to providing exceptional water filtration solutions. With their unique features, advanced technologies, and hassle-free maintenance options, these models cater to a variety of needs, ensuring that users receive clean, great-tasting water in any setting. Whether for a bustling restaurant or a small café, Everpure continues to lead the way in water filtration innovation.