24
FX20 MOTORIZED TREADMILL
MOTION CONTROL OPERATION
How to use MOTION CONTROL (Note: photos may vary from actual treadmill):
1.Press the 
button on the console to switch the motion control function on and off:
•When the LED light is ON the MOTION CONTROL is active.
•When the LED light is OFF the MOTION CONTROL is off.
2.After switching on the MOTION CONTROL wave your right hand approximately 6 inches above the motion sensor on the right handle bar to increase the speed. The sensor will sound one short BEEP per scan and speed up by 0.1 MPH per BEEP. Holding your right hand approximately 6 inches above the right sensor constantly results in the sensor sounding one long BEEP per second and speeding up by 0.5 MPH per BEEP.
3.Wave you left hand approximately 6 inches above the motion sensor on the left handle bar to decrease the speed. The sensor will sound one short BEEP per scan and decrease speed by 0.1 MPH. Holding your left hand approximately 6 inches above the left sensor constantly results in the sensor sounding one long BEEP per second and decreasing speed by 0.5 MPH per BEEP.
4.Wave both hands approximately 6 inches above both motion sensors at the same time. The sensor will sound two short BEEPs then stop the belt.
•Always switch off the MOTION CONTROL
function by pressing the 
button before turning off the power to the treadmill.
2.Use right sensor to speed up.
3.Use left sensor to slow down.
4.Use both sensors to stop belt.
Visit us at: www.evofitness.com
