QUICK FACTS
CALL 1-800-888-2468
TO FIND A LOCAL AUTHORIZED SERVICE CENTER NEAR YOU FOR REPAIRS AND SERVICE PART PURCHASES.
GAS
OIL
WATER
PRESSURE
ADJUSTMENT
PUMP
THERMAL
RELIEF VALVE
HOSE
ENGINE
SOAP/CHEMICALS
NOZZLE
MAINTENANCE
SCHEDULE
STORAGE OR
WINTERIZING
Use fresh high quality unleaded gas.
Add stabilizer to fuel tank and run engine for 5 minutes before storage.
Engine oil: Refer to engine owners manual supplied with this unit.
Use only cold water.
Do not operate unit with clogged or missing water filter/screen.
Do not operate unit without adequate water supply to pump. Adequate water supply is a minimum of 20 psi and 5 gpm.
The pressure setting is preset at the factory to achieve optimum cleaning. If you need to lower the pressure setting, refer to the operation manual for proper procedure.
Pull gun trigger every 2 minutes while engine is running. Do not allow water to freeze in pump.
For cold weather or long term storage refer to the operation manual for proper procedure.
Never leave unit running for more than 2 minutes without pulling gun trigger; doing so could cause damage to pump and void warranty.
Pump is equipped with a thermal relief valve. If the water overheats, this valve will open and allow a gush of water to escape. Once the water is released, the valve closes allowing the pump to operate normally.
Do not allow hoses to contact the HOT engine muffler during or after use. Never pull the hose to move the unit.
Do not adjust or attempt maintenance without consulting engine manual or an authorized engine service center.
Add stabilizer to fuel tank and run engine for 5 minutes before storage. Always turn on the water before starting the engine.
Use only soaps and chemicals designed for pressure washer use.
Keep nozzle unclogged. Refer to manual for cleaning procedures. Chemical/soap cannot be applied in high pressure setting. Only in low setting.
Follow recommended maintenance schedule for engine & pump. Refer to manuals.
Draw clean water through chemical inlet.
Add stabilizer to fuel tank and run engine for 5 minutes before storage. Do not allow water to freeze in pump, gun, wand or hoses.
For cold weather or long term storage refer to the operation manual for proper procedure.
ALWAYS REFER TO THE MANUALS SUPPLIED WITH THIS UNIT
D27935 | 22- ENG |
