Exmark 000 & higher, 850 manual Using the Grass Bag, Danger, Operation

Models: 000 & higher 850

1 40
Download 40 pages 46.04 Kb
Page 20
Image 20
Using the Grass Bag

Operation

Figure 17

1.

Front wheel shaft

4.

Front quadrant block cut

 

assembly

 

heights

2.

Pull up

5.

Pull outward

3.

Height adjuster

6.

Shaft groove

2.Insert the front wheel shaft assembly into the desired cut height setting in the front quadrant block. Lower the height adjuster into the groove on the front wheel shaft. Pull and push the wheel shaft assembly to make sure it has locked into place.

Using the Grass Bag

Installing the Grass Bag

1.Stop the engine and wait for all moving parts to stop.

2.Open the rear door.

3.Grasp the handle on the bag and set the rear of the bag frame onto the handle bracket notch (Figure 18).

Figure 18

1.

Bag

4.

Handle bracket notch

2.

Handle

5.

Rear door

3.

Bag frame

6.

Lower

4.Once the bag is seated, lower the rear door onto the bag.

• Mowing with the Grass Bag

Manual background WARNING

A worn grass bag could allow small stones and other similar debris to be thrown in the operator’s or bystander’s direction. Thrown objects can result in serious personal injury or death to the operator or bystanders.

Check the grass bag frequently. If it is damaged, install a new Exmark replacement bag.

Cut the grass until the bag is full.

Note: Do Not overfill the bag.

Removing the Grass Bag

1.Stop the engine and wait for all moving parts to stop.

2.Raise the rear discharge door and grasp the handle on the bag.

3.Lift the bag off of the lawn mower and lower the rear discharge door.

4.Gradually tip the bag forward to empty the clippings.

5.To install the bag, refer to the section on Installing the Grass Bag.

Manual background DANGER

If the discharge door does not close completely, the lawn mower could throw objects. Thrown objects can result in serious personal injury or death to the operator or bystanders.

Never open the door to the discharge opening when the engine is running.

If you cannot close the door because the grass clippings clog the discharge area, stop the engine and gently move the discharge door handle back and forth until you can close the door completely. If you still cannot close the door, remove the obstruction with a stick, not your hand.

20

Page 20
Image 20
Exmark 000 & higher, 850 manual Using the Grass Bag, Danger, Operation