Exmark 4500-450 manual Specifications, Model Numbers, Systems

Models: 4500-450

1 56
Download 56 pages 3.99 Kb
Page 13
Image 13

Specifications

Specifications

Model Numbers

Serial Nos: 790,000 and Higher

QST20BE422; QST22BE482; QST24BE522

Systems

Engine

Engine Specifications: See your Engine Owner’s Manual

RPM:

20HP

Full Speed: 3300 ±100 (max) RPM (No Load)

Idle: 1650 (min) RPM

22HP & 24HP

Full Speed: 3650 ±100 (max) RPM (No Load)

Idle: 1650 (min) RPM

Fuel System

Capacity: 4.0 gal. (15.1 L)

Type of Fuel: Regular unleaded gasoline, 87 octane or higher.

Fuel Filter:

Briggs & Stratton P/N 695666

Fuel Shut-Off Valve: 1/4 turn increments (“ON”, “OFF”)

Electrical System

Charging System: Flywheel Alternator

Charging Capacity: 16 amps

Battery Type: BCI Group U1

Battery Voltage: 12 Volt

Polarity: Negative Ground

Fuses: One 25 amp, one 20 amp; one 15 amp blade type

Diode: TVS

Safety Interlock System

PTO must be disengaged, brake engaged, and motion control levers out (neutral lock) to start engine. (It is not necessary for the operator to be in the seat to start the engine.)

Operator must be in seat when PTO is engaged, brake is disengaged, or motion control levers are moved in or engine will stop.

Engine will stop if either the left, the right, or both levers are moved from neutral lock position while brake is engaged.

Operator Controls

Steering and Motion Control:

Note: Motion control levers are adjustable to two heights.

Separate levers, on each side of the console, control speed and direction of travel of the respective drive wheels.

Steering is controlled by varying the position of the levers relative to each other.

Moving motion control levers outward (in slots) locks the drive system in neutral.

PTO Engagement Switch: Engages electric clutch (to drive belt) which engages mower blades.

Parking Brake Lever: Engages parking brake.

Deck Height Adjustment Pin: Sets cutting height to desired position.

Deck Lift Assist Lever: Foot pedal that assists in raising the deck.

Seat

Type: Standard seat with high back, foam padded with spring suspension and armrests (armrests are optional on the 42 inch unit).

Mounting: Hinged to tilt up for access to hydraulic pumps, battery and other components. Held in tilted position with lanyard. Adjustable fore and aft.

13

Page 13
Image 13
Exmark 4500-450 manual Specifications, Model Numbers, Systems