Maintenance
speed control linkage (see Figure 16) until the tabs are positioned correctly.
Figure 16
Viewed from Left Side of Unit
1. Neutral Safety Switch | 3. 5/16 inch (7.9 mm) |
2.Actuating Tab in neutral position
3.Pull the speed control lever back to neutral. Check that the neutral safety switch actuating tab has depressed the plunger of the switch so that there is about 5/16 inch (7.9 mm) between the tab and the switch (see Figure 16). If necessary, move the switch fore and aft.
•Adjust Neutral Control Linkages:
1.Raise the rear of the machine up onto jack stands high enough to raise the drive wheels off of the ground.
2.Start the engine and move the throttle ahead to the full throttle position. Place the neutral lock latches in the “forward” position as shown in Figure 4. Release the park brake and move the speed control lever to the
Note: The OPC levers must be held down and the park brake must be disengaged whenever the speed control lever is moved out of neutral or the engine will kill.
3.Squeeze the respective drive lever until an increased resistance is felt, this is where neutral should be.
If the wheel turns while holding the drive lever in neutral, the neutral control linkages need to be adjusted. If the wheel stops then go to step 7.
Figure 17
Viewed from Left Side of Unit
1. | Neutral Control Linkage | 5. | Speed Control Linkage |
2. | Hydro Control Linkage | 6. | Adjust |
|
|
| approximately 1/4 |
|
|
| turn increments and |
|
|
| |
3. | Drive Lever Linkage | 7. | Loosen nut |
4. | Speed Control Crank | 8. | Yoke |
4.Loosen the nut against the neutral control linkage yoke as shown in Figure 17.
5.Adjust the neutral control linkage until the respective drive wheel stops when the lever is pulled against the neutral spring (neutral position). Turn the adjusting bolt approximately 1/4 turn clockwise if the wheel is turning in reverse or turn the bolt approximately 1/4 turn counterclockwise if the wheel is turning forward. Release the drive lever to the forward drive position and squeeze back into the neutral position. Check to see if the wheel stops. If not, repeat the above adjustment procedure.
6.Make this adjustment on both sides.
7.After adjustments are made and the wheels stop when the drive levers are in the neutral position, tighten the nuts against the yokes.
•Adjust Hydro Control Linkages:
1.Place the speed control lever in the “neutral” position. This adjustment is again made with rear of machine on jack stands and engine running at full throttle. OPC levers will have to be held down and the park brake must be
34
