Operation
Figure 14
Large Decks — View from Top of Blower
1. | Impeller sheave | 3. Spring loaded idler |
2. | Deck sheave |
|
17.Position the belt cover at an angle and slide it under the mower frame (see Figure 15).
Figure 15
1. Blower | 3. Mower frame |
2.Belt cover
Figure 16
1. Blower | 3. Deck lip |
2.Belt cover
20.Install the knob and its hardware.
21.Slip the upper and the lower tubes together.
22.Insert the upper tube into the hopper seal – push in then pull out so that the seal is extended outward.
23.Align the dimple on the upper tube with the end of hopper seal and center between the two screws as shown in Figure 17.
18.Push down on the back of the cover and slide it backwards under the blower.
19.Slide the belt cover forward until it is seated under both lips on the deck.
Figure 17
1.Dimple
24.Set the deck in lowest cutting position.
25.Slide the lower tube onto the blower and attach the latches. (Make sure that the upper tube does not move out of alignment).
26.If the lower tube is replaced, drill three 7/32 inch holes in the lower tube using the upper tube holes as reference. See Figure 18.
27.Remove the tubes from unit and assemble the upper and the lower tubes using three
16
