WARNING
POTENTIAL HAZARD
♦Incorrect installation of the blade or components used to retain the blade can be dangerous.
WHAT CAN HAPPEN
♦Failure to use all original components and assembled as shown could allow a blade or blade component to be thrown out from under the deck resulting in serious personal injury or death.
HOW TO AVOID THE HAZARD
♦Always install the original Exmark blades, blade bushings, spring disc washers, and blade bolts as shown.
4.1.6Check safety interlock system.
Service Interval: Daily
NOTE: To prevent engine
a)Check starting circuit. Starter should crank with parking brake engaged, PTO disengaged and motion control levers moved out in the neutral lock position. The operator does not need to be in the seat to start the engine.
Try to start with operator in seat, parking brake disengaged, PTO disengaged and motion control levers in the neutral lock position - starter must not crank.
Try to start with operator in seat, parking brake engaged, PTO engaged and motion control levers in the neutral lock position - starter must not crank.
Try to start with operator in seat, parking brake engaged, PTO disengaged, and the left motion control lever in, starter must not crank, repeat again with the right lever in, then with both levers in - starter must not crank.
b)Check kill circuits. Run engine at
Run engine at
Run engine at
Again, run engine at
Repeat again moving the right lever in, then moving both levers in - engine must initiate shutdown whether operator is on seat or not.
NOTE: If machine does not pass any of these tests, do not operate. Contact your authorized EXMARK SERVICE DEALER.
24