12. Wipe dirt from the base and the cover with a moist |
rag. |
1
Note: Be careful to prevent dirt and debris from |
entering the air duct leading to the carburetor. |
13. Install the air cleaner elements and ensure that they are |
properly positioned. |
A
2
B
1
14. Securely install the cover with the 2 wing bolts. |
Maintaining the Blade
Always mow with a sharp blade. A sharp blade cuts cleanly and without tearing or shredding the grass blades.
1.Stop the engine and wait for all moving parts to stop.
2.Disconnect the wire from the spark plug (Fig. 6).
3.Drain the gasoline from the fuel tank.
4.Tip the lawn mower onto its right side (air cleaner up) (Fig. 17).
2
1 
3 757
Figure 17
1. Blade | 3. Accelerator |
2. Bolt and lock washer
Inspecting the Blade
Carefully examine the blade for sharpness and wear, especially where the flat and the curved parts meet (Fig. 18A). Because sand and abrasive material can wear away the metal that connects the flat and curved parts of the blade, check the blade before using the lawn mower. If you notice a slot or wear (Figs. 18B and 18C), replace the blade; refer to Removing the Blade on page 17.
|
| 3 | 1 |
|
|
| |
| C |
|
|
|
| 4 | 270 |
|
|
| |
|
| Figure 18 |
|
1. | Sail | 3. | Wear |
2. | Flat part of blade | 4. | Slot formed |
|
|
|
|
Note: For the best performance, install a new blade before the cutting season begins. During the year, file down any small nicks to maintain the cutting edge.
Danger
A worn or damaged blade can break, and a piece of the blade could be thrown into the operator's or bystander's area, resulting in serious personal injury or death.
•Inspect the blade periodically for wear or damage.
•Replace a worn or damaged blade.
Removing the Blade
1.Grasp the end of the blade using a rag or a thickly padded glove.
2.Remove the blade bolt, the lockwasher, the accelerator, and the blade (Fig. 17).
17
