Extron electronic 3G-AE 100 manual Analog Output Connector Wiring, 3G-AE100 Panels and Cabling

CLoop Through connector — If necessary, plug in an output device to the

Loop Through connector. The SDI input signal is equalized, re-clocked, and routed to the Loop Through connector. This connector may also be used for cascading to another 3G-AE 100.

NOTE: It is not required to connect a device to the Loop Through connector in order to extract audio from the input device.

DAnalog Outputs — Connect up to four audio output devices to the Analog Outputs, using a cable with a balanced or unbalanced 3.5 mm, 5-pole captive screw connector. Wire as shown below.

	Tip
	Ring
	Sleeves
Do not tin the wires!	Tip
	Ring

	No Ground Here
L	Tip
	Sleeves
	Tip

R

No Ground Here

L R

Balanced Audio Output Unbalanced Audio Output

Figure 4. Analog Output Connector Wiring

ATTENTION: Connect the sleeve to the ground (Gnd) terminal. Connecting the sleeve to a negative (-) terminal will damage the audio output circuits.

EGroup Select DIP switch — see the Operation section on the next page for instructions on using the Group Select DIP switch.

3G-AE 100 • Panels and Cabling 4