Extron electronic 68-1316-02 Command and Response Table for SIS Commands, Input Selection Mode

Command and Response Table for SIS Commands

Command	ASCII Command	Response	Additional Description
	(Host to Unit)	(Unit to Host)
Input Selection
Select video and audio input	X! !	In X! • All ]	Select audio (if available) and video
			input X!.
			X! = input number: 0 through
			number of inputs on the switcher.
			0	= deselect (mute) all inputs.
Select video input only	X! &	In X! • Vid ]	Select video input X! (audio models
			only).
			0	= deselect (mute) all inputs
Select audio input only	X! $	In X! • Aud ]	Select audio input X! (audio models
			only).
			0	= deselect (mute) all inputs
			When audio is broken away, the LED
			for the selected audio input blinks.
Input Selection Mode
Enable and disable auto-input	X$ #	F X$ ]	(Non-audio SW 2/4 DVI Plus models
switching			only) Automatically select the
			connected, active input.
			X$ = input selection mode.
			For X$:
			1	= normal switch mode
			2	= auto-input switch mode
Input Video Signal Sensing
Request status of all inputs	0LS	Sig X@ • X@ ... X@ ] Show the presence or absence of
			a signal at each input. Inputs are
			shown in numerical order.
			X@ = input signal status. For X@:
			1	= signal present
			0	= signal not present
NOTE: This command is case-sensitive.
Request status of an individual	X! LS	X@ ]	View whether a signal is present for
input			input X!.
NOTE: This command is case-sensitive.
Video Output Muting
Video output mute	X@ B	Vmt X@ ]	Mute the output video signal.
Read video output mute	B	X@ ]	Show output video muting status X@.
			For X@:
			1	= muted
			0	= unmuted
Audio Output Muting
Audio output mute	X@ Z	Amt X@ ]	Mute the output audio signal (audio
			models only).
Read audio output mute	Z	X@ ]	Show output audio muting status X@.
			For X@:
			1	= muted
			0	= unmuted

SW DVI Plus Series • Remote Configuration and Control 20