Installation and Operation, cont’d
Furniture mounting
Furniture mount the ASA using the optional mounting kit (part
1. | Remove rubber feet if they were previously installed on the |
| bottom of the ASA. |
2. | Attach the furniture mounting brackets to the ASA with the |
| machine screws provided. |
3. | Hold the ASA with the attached brackets against the |
| underside of the table or other furniture. Mark the location |
| of the screw holes of the bracket on the mounting surface. |
4. | Drill 3/32” (2 mm) diameter pilot holes, 1/4” (6.3 mm) deep |
| in the mounting surface at the marked screw locations. |
5. | Insert #8 wood screws into the four pilot holes. Tighten |
| each screw into the mounting surface until just less than |
| 1/4” of the screw protrudes. |
6. | Align the mounting screws with the slots in the brackets |
| and place the ASA against the surface, with the screws |
| through the bracket slots. See the illustration below. |
7.Slide the ASA slightly forward or back, then tighten all four screws to secure the unit in place.
Figure
Projector mounting
Projector mount the ASA using the optional mounting kit (part
1. | Remove rubber feet if they were previously installed on the |
| bottom of the ASA. |
2. | Attach the projector mounting brackets to the ASA with the |
| machine screws provided. |
3. | Secure the ASA to a projector mount or other surface by |
| inserting the mounting bolt through the bracket’s slotted |
| hole, as shown below. |
Projector
Mounting
Bracket
Mounting |
Bolt |
Ceiling
Digital Projector
Figure
ASA Series • Installation and Operation | ASA Series • Installation and Operation |