Connections, Indicators, and Controls
E Audio output connector — Insert a 3.5 mm,
screw connector into this connector for a balanced or unbalanced 1 kHz sine wave audio tone.
NDo not tin the stripped power supply leads before installing the captive screw connector. Tinned wires are not as secure in the captive screw connectors and could pull out.
CAUTION
For unbalanced audio, connect the sleeve(s) to the ground contact.
DO NOT connect the sleeve(s) to the negative
| 3/16" (5 mm) MAX. |
Tip | Tip |
Ring | NO Ground Here |
Sleeve (s) | Sleeve (s) |
Tip | Tip |
Ring | NO Ground Here |
Balanced Output Unbalanced Output
Figure 6 — BBG 6 audio wiring
F Power connector — Plug the external 12 V power supply into this
CWhen connecting the power supply, voltage polarity is extremely important. Applying power with incorrect voltage polarity could damage the power supply and the BBG 6 A. Identify the power cord negative lead by the ridges on the side of the cord or the black heat shrink wrapping around it.
To verify the polarity before connection, plug in the power supply with no load and check the output with a voltmeter.
As an alternative, you can use an Extron P/S 100 Universal
12 VDC Power Supply (part
G Version label — Differentiates the standard (NTSC and PAL signals) versus Japanese (BBG 6 A J, NTSC signals only) versions of the BBG 6 A.
Specifications
Blackburst output
Number/signal type | 6 blackburst (two can be switched to |
| color bars) |
Connectors | 6 BNC female |
Standards |
|
BBG 6 A | |
| CCIR |
BBG 6 A J | |
Impedance | 75 ohms |
Sync level |
|
BBG 6 A | 40 IRE for NTSC, 43 IRE for PAL |
BBG 6 A J | 40 IRE for NTSC |
Color burst level |
|
BBG 6 A | 40 IRE for NTSC, 43 IRE for PAL |
BBG 6 A J | 40 IRE for NTSC |
Setup level |
|
BBG 6 A | 7.5 IRE (NTSC) or 0 IRE (PAL) |
AA
| + |
SECTION | - |
12 V |
Power Supply
Output Cord
Figure 7 — Power connector wiring
3/16” (5 mm) MAX.
+
-
Captive Screw
Connector
BBG 6 A J | 0 IRE (NTSC) |
Tolerance for all levels | ±3% |
Subcarrier levels |
|
BBG 6 A | NTSC 3.579545 ±3 Hz |
| PAL 4.433618 ±3 Hz |
BBG 6 A J | NTSC 3.579545 ±3 Hz |
NDo not tin the stripped power supply leads before installing the captive screw connector. Tinned wires are not as secure in the captive screw connectors and could pull out.
WThe two power cord wires must be kept separate while the power supply is plugged in. Remove power before continuing.
BBG 6 A • Connections, Indicators, and Controls
BBG 6 A • Specifications, Parts, and Accessories |