Extron electronic DVI DL 101 A

DVI DL 101 • Installation and Opeation

Installation and Operation, cont’d

2-16

DVI DL 101

A

Appendix A

Speciﬁcations, Parts, and

Accessories

Speciﬁcations

Included Parts

Optional Accessories

Cables and Adapters

5. Lift each jumper off its pins and slide it down onto the

inside and middle pins. See the illustration below.

DVI-DUAL LINK INPUT

DVI DL 101

Jumper Pin Sets J4 and

J5 Inside Unit

DDC Buffer

Bypassed

(Default)

DDC Buffer

Enabled

Jack Screw

Nut

Remove screws from

sides and top (7).

Slide forward,

then up.

6. Replace the top cover onto the unit, and slide it back until

the DVI input connector protrudes through its slot in the

front panel.

7. Replace the two jack screws and the seven Philips screws

that you removed in step 1.

Contents

Main DVI DL 101 2008 Extron Electronics. All rights reserved. Users Manual Dual Length DVI Cable Equalizer 68-1574-01 Rev. A 06 08 Precautions Instrucciones de seguridad Espaol Caution Warning Attention FCC Class A Notice N Table of Contents Chapter One Introduction Chapter T wo Installation and Operation Appendix A Specications, Parts, and Accessories Chapter One Introduction DVI DL 101 Intoduction Introduction DVI DL application diagram 1-3 1-2 DVI DL 101 Intoduction Chapter Two Installation and Operation Installation and Operation DVI DL 101 Installation and Opeation 2-3 2-2 Under-furniture mounting Under-furniture mounting the DVI DL Through-furniture mounting DVI DL 101 Installation and Opeation 2-6 Projector mounting N PMK 300 projector mounting a receiver N 2-8 N 2-10 2-11 N a b N 2-12 2-13 c N d 2-14 Enabling the DDC Buffer Jumpers on the internal board in default (outside) position 2-16 A Appendix A Specications, Parts, and Accessories Specications Included Parts Optional Accessories Cables and Adapters Specications, Parts, and Accessories A-2 A-3 Specications DVI DL Specications, Parts, and Accessories, contd A-4 A-5 Included Parts