PowerCage™ FOX AEX 104 • Setup Guide
This guide provides instructions for an experienced installer to set up and operate the Extron PowerCage FOX AEX 104 fiber audio extractor. The PowerCage FOX AEX 104 is a double slot board for the PowerCage 1600 enclosure that provides up to 4 extraction points.
NOTE: The PowerCage FOX AEX 104 is compatible with all Extron FOX |
products except for FOX 3G |
Installation
Step 1 — Input Data Rate Selection
The DIP switch on the main board switches the PowerCage FOX AEX 104 between 2G and 4G input data rates. Using an Extron Tweeker or small screwdriver, move DIP switch 2 up (on position) for 2G input data rates or down (off position) for 4G input data rates. DIP switch 1 is a spare. The default rate is 4G (off or down).
NOTE: 4G and 2G data rates apply to all inputs. These selectable rates are |
not for individual inputs. |
CAUTION: | Ensure all fiber extenders are compatible with the desired data |
rate. |
|
Step 2 — Board Installation
O 1 | 2 |
N |
|
NOTE: The PowerCage FOX AEX 104 is |
or removed without turning off or disconnecting the power to the |
PowerCage enclosure. |
CAUTION: Use ESD precautions when installing a board to avoid damaging it. Keep the board in the
Use proper grounding techniques during installation.
a.If applicable, remove as many blank plates or previously installed boards from the rear of the
PowerCage enclosure as necessary to fit the | 16 available single board slots or |
PowerCage FOX AEX 104. | 8 double board slots |
| |
b. With the connectors facing away from the |
|
PowerCage enclosure, align the PowerCage FOX | Power |
AEX 104 vertically with the top and bottom slide | Supply |
| |
posts in the selected enclosure slot. | Screws |
|
c. Carefully slide the board into the slot and push it firmly into place.
d. Tighten the screws to secure the board to the enclosure.
NOTE: Use a tool to fully tighten the screws after initial installation and |
subsequent removal and replacement of the boards. |
