Extron electronic ADA 2/GLI 350xi Three, Operation, Under-furnituremounting, Installation, cont’d

Installation, cont’d

Under-furniture mounting

The GLI 350xi or ADA 2/GLI 350xi can be mounted under furniture, such as a desk or table, using the optional MBU 125 mounting kit (Extron part #70-077-01), as follows.

1.	If rubber feet were previously installed on the bottom of
	the unit, remove them.
2.	Attach the mounting brackets to the GLI with the provided
	machine screws.

Under-furniture mounting of the GLI

3.	Hold the unit with the brackets attached against the
	underside of the table or other furniture. Mark the location
	of the screw holes of the bracket on the mounting surface.
4.	Drill four pilot holes, each 3/32" (2 mm) in diameter by
	1/4" deep (6.3 mm) in the mounting surface at the marked
	screw locations.
5.	Insert #8 wood screws into the four pilot holes. Tighten
	each screw into the mounting surface until just less than
	1/4" (6.3 mm) of the screw head protrudes.
6.	Align the mounting screws with the slots in the brackets
	and place the unit against the surface, with the screws
	through the bracket slots.
7.	Slide the unit slightly forward or back, then tighten all four
	screws to secure the unit in place.

GLI 350xi & ADA 2/GLI 350xi

Chapter3Three

Operation

Front Panel Features and Operation

Rear Panel Features and Operation

2-6 GLI 350xi & ADA 2/GLI 350xi • Installation