Extron electronic HSA 800, HSA 802 Packaging for Shipment, Contd

Surface Access Products • Packaging for Shipment

Packaging for Shipment, Cont’d

6. Release (extend) the top panel.

7. Insert the HSA 800/802 and the clamshell into one of the

foam shells (figure B-4). Either open end of the clamshell

and the open top panel will fit into the recesses in the

foam.

Figure B-4 — Installing the foam shell

8. Insert the opposite end of the HSA 800/802 and the

clamshell into the remaining foam shell (figure B-5).

Firmly push the foam shells together as far as they will go

to completely suspend the HSA and clamshell. The sides

of the clamshell protrude through slots in the foam.

9. Lower the foam-protected HSA into the shipping carton

(figure B-6).

10. Close the shipping carton and seal it with high quality

shipping tape.

11. Ship the HSA to Extron using a reputable shipping

company.

B-5B-4

Figure B-5 — HSA suspended in the foam

Figure B-6 — Placing the HSA in the shipping

carton

Contents

Main Users Manual HSA 800 & 802 Extron Electronics, USA Extron Electronics, Europe Extron Electronics, Asia Extron Electronics, Japan Precautions Instrucciones de seguridad Espaol Caution Warning Attention Table of Contents Page Surface Access Products Introduction 1-3 Introduction xi About the HSA Hideaway Enclosures Figure 1-1 HSA 800 hideaway enclosure 1-2 Chapter Two Installation Features Installation 2-3 Figure 2-1 Prepared mounting template 2-2 Preparing the Table and Mounting the Enclosure 2-52-4 Figure 2-2 Cutting the opening with a router 2-6 Figure 2-3 Mounting the HSA 800 enclosure 2-7 Cabling and Installing the AAPs Figure 2-4 Removing the front panel from an HSA 800 2-8 RGB 580xi SI AAP 2-9 Cabling the enclosure Figure 2-6 HSA 800 and HSA 802 enclosure underside connectors Figure 2-7 HSA 802, US/domestic RJ-45 connectors Figure 2-8 HSA 802, IEC/international RJ-45 connectors Figure 2-9 Changing the connector icon Bezels Surface Access Products Chapter Three Maintenance and Modifications Maintenance and Modifications 3-2 Replacing an AAP 3-3 RGB 580xi SI AAP Removing and Replacing the Enclosure 3-53-4 Figure 3-3 Removing the HSA 802 from the table 3-73-6 Figure 3-4 Disconnecting the interior AC cable Adding a Second Connector Panel Replacing the Gas Lift 4,7 3-93-8 5,6 2,9 Figure 3-5 Changing the gas lift Adjusting the Top Surface Adjusting the height of the top surface 3-11 Figure 3-5 Location of the height adjustment screw Adjusting the top surface level A Appendix A Reference Information Reference Information A-3A-2 Specifications General A BC Reference Information, contd A-4 HSA 800/802 EU Part number A-5 HSA 800/802 UK Part number Reference Information, contd Top Plate Dimensions CUT-OUT TEMPLATE FOR EXTRON'S HSA 800 & 802 SURFACE CUT-OUT AREA = C x D Page Figure B-1 HSA 800/802 return kit B-3B-2 Figure B-2 Attaching the clamshell Figure B-3 Installing protective strips Packaging for Shipment Packaging for Shipment, Contd B-5B-4