Extron electronic P/2 DA2XI Under-furniture mounting, Through-furniture mounting

P/2 DA2xi • Installation and Operation

Installation and Operation, cont’d

(2) 4-40 x 3/16"

Screws

Use 2 mounting holes on

opposite corners.

VersaTools Rack Shelf

1/4 Rack Width Front

False Faceplate

Under-furniture mounting

The P/2 DA2xi can be mounted under a table or other

horizontal surface using an optional Extron MBU 125 under-

desk mounting kit (part #70-077-01). Mount the unit under a

desk or table, as follows:

1. Secure the under-desk mounting brackets to the

distribution ampliﬁ er with the four machine screws

provided in the mounting kit.

2. Hold the unit with attached brackets against the underside

of the desk or other furniture. Mark the location of holes

for screws on the desk.

3. Drill 1/4" (6.4 mm) deep, 3/32" (2 mm) diameter pilot

holes in the table or desk at the marked screw locations

from the underside or inside (the concealed side) of the

furniture, where the distribution ampliﬁ er will be located.

4. Insert the four wood screws into the pilot holes. Fasten

each screw into the installation surface until just less than

1/4" of the screw head protrudes.

5. Align the installed screws with the slots in the mounting

brackets, and place the unit against the surface, with the

screws through the bracket slots.

6. Slide the unit slightly forward or back, then tighten all four

screws to fasten it in place.

The distribution ampliﬁ er can be mounted through a desk or

other furniture using an optional Extron MBD 129 through-desk

mounting kit, part #70-077-02. Mount the P/2 DA2xi through a

desk or table, as follows: