P/2 DA2xi • Installation and Operation
Installation and Operation, cont’d
6P/2 DA2xi • Installation and Operation
7
1. Loosely attach the mounting brackets to the unit using
the four machine screws and washers supplied with the
mounting kit.
2. Hold the distribution amplifi er against the inside of the
surface through which it will be mounted. Mark the four
screw holes on the inside of the surface to which you are
mounting the device.
3. Drill four pilot holes, each 3/32" in diameter by 1/4" deep,
where you made marks.
4. Using the four wood screws provided, secure the brackets
to the mounting surface.
5. Slide the unit up and down in the mounting brackets until
the face of the unit is at the desired height. Tighten the
screws that secure the bracket in place.
If the screws are inaccessible to a screwdriver:
a. Mark the location of the brackets relative to the screws.
b. Remove the P/2 DA2xi from inside the furniture.
c. Tighten the screws.
d. Replace the unit inside the surface (step 4).
Projector mounting
Extron
PMK 350
Multi-product Projector
Mounting Kit
Extron
P/2 DA2xi
Cover Sheet
Front Plate
Rear Plate
U-bolt
Projector mounting the P/2 DA2xi using the PMK 350
Projector Mount Kit
The PMK 350 Low Profi le Projector Mount Kit is an above-
projector mounting kit that attaches to a 1" to 2" diameter
projector mounting pole. It can hold more than one device,
in a variety of sizes. The PMK 350 is available in black
(part #70-563-02) or white (part #70-563-03).
Follow these steps to mount the P/2 DA2xi on the PMK 350
bracket as follows:
1. Remove the front and back panels from the
PMK 350, using an Extron Tweeker or other small Philips
screwdriver. (Retain the screws to reattach the plates when
you are fi nished.)
2. Remove any rubber feet from the bottom of the P/2 DA2xi.
3. Secure the P/2 DA2xi to one side of the mounting bracket,
using two of the supplied 4-40 x 3/16" screws in opposite
(diagonal) corners.
4. Using the two included tie wraps, strap the P/2 DA2xi
power supply to the PMK 350 bracket.
5. Place the bracket around the projector ceiling mounting
pole as shown in the previous illustration.
6. Place the rubberized contoured base against the pole and
opposite the back plate. The pole should fi t snugly into the
depression in the center of the contoured base.
7. Align the two slotted holes in the bottom of the L-shaped
bracket with the two slotted holes in the base of the
PMK 350, on either side of the opening for the pole.
Attach the L-bracket to the base by inserting two provided
6-32 x 5/16" screws through the aligned slots.
8. Insert the two legs of the provided square U-bolt through
the following parts in the order they are listed below:
a. The slotted holes on the back side of the bracket mount
plate
b. The round holes in the rubberized contour base
c. The round holes in the L-shaped bracket
• For a typical (1.5" to 2.0" diameter) pole — You can
use the supplied square U-bolt, which fi ts a typical
ceiling pole.
• For a smaller pole — Locally obtain a square U-bolt
that fi ts your ceiling pole. The slotted holes on the
bracket can accommodate a square U-bolt for pole
sizes from 1.0" to 2.0" in diameter.
9. Move the PMK 350 up to the desired location on the ceiling
pole, as close to the ceiling as desired.