Furniture mounting
For optional furniture mounting, mount the unit using the mounting kit MBU 125
(part #70-077-01, provided with the P/2 DA2xi MT) as follows:
1. Attach the mounting brackets to the distribution amplifier with the provided machine
screws, as shown below.
INPUT MONITOR
Figure 5. Furniture Mounting Option
2. If feet were previously installed on the bottom of the unit, remove them.
3. Hold the unit with the attached brackets against the underside of the table or other
furniture. Mark the location of the screw holes of the bracket on the mounting surface.
4. Drill 3/32 inch (2 mm) diameter pilot holes, 1/4 inch (6.3 mm) deep in the mounting
surface at the marked screw locations.
5. Insert #8 wood screws into the four pilot holes. Tighten each screw into the mounting
surface until just less than 1/4 inch of the screw head protrudes.
6. Align the mounting screws with the slots in the brackets and place the unit against the
surface, with the screws through the bracket slots.
7. Slide the unit slightly forward or back, then tighten all four screws to secure the unit in
place.
P/2 DA2xi MT User Guide • Reference Information 7