Extron electronic P/2 DA2XI MT setup guide Power up, Set DIP switches, Setup Guide -­P/2 DA2xi MT

Models: P/2 DA2XI MT

1 2
Download 2 pages 38.51 Kb
Page 2
Image 2
Setup Guide —­ P/2 DA2xi MT

Setup Guide —­ P/2 DA2xi MT

 

Tip

 

NO GROUND HERE.

 

Sleeve(s)

Do not tin the wires!

Tip

NO GROUND HERE.

 

L

Tip

Ring

 

 

Sleeve(s)

R

Tip

Ring

 

Step 4 — Power upSECTION A–AStep 5 — Set DIP switchesL R

Unbalanced Stereo Output Balanced Stereo Output

CConnect the sleeve to ground (Gnd). Connecting the sleeve to a negative (-) terminal will damage the audio output circuits.

Step 4 — Power up

Plug the external 12 V power supply into this 2-pole captive screw connector. The included power supply is shipped with a plug installed on the DC output cord. If the DC output cord needs to be cut to a different length, see the following figure and notes for reinstalling the DC output plug.

Smooth

Ridges

 

A

A

SECTION A–A

Power Supply

Tie Wrap

Output Cord

 

3 Manual backgroundManual background5 Manual backgroundManual background

Captive Screw

Connector

CWhen you connect the power supply, voltage polarity is extremely important. Applying power with incorrect voltage polarity could damage the power supply and the amplifier. Identify the power cord negative lead by the ridges on the side of the cord.

NDo not tin the stripped power supply leads before installing the captive screw connector. Tinned wires are not as secure in the connectors and could pull out. Strip the power cord jacket 5 mm from the end.

WThe two power cord wires must be kept separate while the power supply is plugged in. Remove power before continuing.

To verify the polarity before connection, plug in the power supply with no load and check the output with a voltmeter.

Step 5 — Set DIP switches

These switches affect only the video output (G), not the “monitor” output (D).

The Gain/Peak DIP switch should be on (up) when the output cable is over 100 feet (30.5 m).

The Out Imp DIP switch changes output impedance. If all connections and operations are correct, but the output has no picture, switch to the other position.

Extron USA - West

Headquarters

+800.633.9876

Inside USA / Canada Only

+1.714.491.1500 +1.714.491.1517 FAX

Extron USA - East

Extron Europe

Extron Asia

Extron Japan

Extron China

+800.633.9876

+800.3987.6673

+800.7339.8766

+81.3.3511.7655

+400.883.1568

Inside USA / Canada Only

Inside Europe Only

Inside Asia Only

+81.3.3511.7656 FAX

Inside China Only

+1.919.863.1794

+31.33.453.4040

+65.6383.4400

 

+86.21.3760.1568

+1.919.863.1797 FAX

+31.33.453.4050 FAX

+65.6383.4664 FAX

 

+86.21.3760.1566 FAX

© 2010 Extron Electronics. All rights reserved. www.extron.com

Extron Middle East

+971.4.2991800 +971.4.2991880 FAX

68-713-50

Rev. A

01 10

Page 2
Image 2
Extron electronic P/2 DA2XI MT setup guide Power up, Set DIP switches, Setup Guide -­P/2 DA2xi MT, Section A-A