PCM 240 • Installation Guide
IMPORTANT SAFETY INSTRUCTIONS
Read all instructions before starting installation.
When using this accessory, basic precautions should always be followed, including the following:
WARNING: Risk of Personal Injury. Maximum setup load for the PCM is 50 lbs (22.7 kg).
SAVE THESE INSTRUCTIONS
NOTE: Refer to local building standards and codes to verify that the installation will meet the regulatory requirements. Observe all local and national building and safety codes, UL requirements, and ADA accessibility guidelines.
WARNING: Risk of Personal Injury and property damage. Do not exceed specified weight limits of any component of the installation. Follow the manufacturer's specifications and installation instructions.
The Extron PCM 240 Drop Ceiling Projector Mount is used for hanging
PoleVault® System AV products and various projectors.
The PCM is installed above the drop ceiling and secures the adjustable | Base | |
pipe in a | Points (for Power Sockets, for example) | Plate |
| ||
mounting of the Extron PMK 550 and UPB 25 projector bracket. | Pipe |
|
The key components of the PCM 240 are shown in figure 1. |
| |
Adapter |
| |
Also included in the kit are: | Pipe Adapter Plate |
|
Lock Nuts (4) |
| |
4 turnbuckles, 5 lag eye bolts, 5 concrete anchors, 2 cable clamps, |
| |
| ||
1 safety wire – 15 feet, 2 tie wires – 30 feet, 4 |
| |
Securing |
| |
adhesive pads, escutcheon ring. | Screws (4) |
|
| Pipe Adapter |
Determine the exact location of the installation on the drop ceiling. | Set Screws (2) |
| |
Consider the following: |
|
• The vertical and horizontal offsets of the projector from the proposed location.
• The projector dimensions relative to the image target.
NOTE: See the projector manual for details.
Installation
Step 1 — Mark the Frame and Cut the Ceiling Tile.
a.At the location for the projector, identify the ceiling tile and
b.Remove the predetermined ceiling tile and mark the maximum and minimum throw distances of the projector on the
TIP: Mark the screen direction on the back of the tile to help with orientation of the tile when replacing it after cutting.
c.Place the PCM base plate over the
d.Mark the location of the PCM base plate on the
e.Measure the distances X and Y (see figure 2) from the inner vertical section of the front and left
Figure 1. PCM 240 Parts
X"
Projector
Front
Y"
Minimum and
Maximum
Throw Distance Marks
Figure 2. Minimum and Maximum
Throw Distances
1