Extron electronic QSD 204 manual Quick Start - QSD, Installation, Rear panel video inputs, Step

Quick Start — QSD 204

Installation

Step 1

Refer to the application example at the end of this page. Turn off power to the decoder and input and output devices, and remove power cords from them.

Step 2

Install the four rubber feet on the bottom of the QSD 204 decoder, or mount the decoder in a rack.

Step 3

Attach input devices to the decoder.

Rear panel video inputs

Input 1: Composite video				VIDEO
				1
Input 2: Composite/S-video/Component
Composite Video		S-video (Y/C)		Component Video (R-Y, Y, B-Y)
	B-Y		B-Y		B-Y
	/C		/C		/C
R-Y	Y	R-Y	Y	R-Y	Y
	/VID		/VID		/VID
	2		2		2

Input 3: S-video	S-VIDEO
	3
	RGBS/
	RGBcvS
Input 4: RGBS/RGBcvS
	4

SDI input

Attach an SDI source to this BNC (204 D

Step 5

Plug the QSD 204, and input and output devices into a grounded AC source, and turn on the input and output devices.

Step 6

Use the LCD menu screens (see the next page) or RS-232 programming to configure the decoder. See chapter two for installation and operation procedures, and see chapter three for programming information.

Application example
QSD 204
100-240V 0.3A	VIDEO	INPUTS		R	OUTPUTS	REMOTE
		B-Y	SDI		G	B
				/R-Y	/Y	/B-Y
		/C
	1		S-VIDEO	RGBS/
	R-Y	Y		RGBcvs	V	RGB/R-Y,Y,B-Y
				H		S
		/VID
50/60 Hz		2	3	4

RS-232 Control

LCD Projector

DVD Player

VCR

Monitor

Video Camera

Document Camera

model only).

Step 4

SDI

Attach output devices to the decoder.

Rear panel video outputs

Output BNC connectors

Output 15-pin HD connector

	RGBHV			RGBS
R	OUTPUTS	B	R	OUTPUTS	B
	G			G
/R-Y	/Y	/B-Y	/R-Y	/Y	/B-Y
H	V	S	H	V	S
R	OUTPUTS	B	OUTPUTS		B
	G		R	G
/R-Y	/Y	/B-Y	/R-Y	/Y	/B-Y
H	V	S	H	V	S
	RGsB		Component Video (R-Y, Y, B-Y)

You can connect both outputs	RGB/R-Y,Y,B-Y
simultaneously to two different
displays. The sync format is
the same for both outputs.