Installation, cont’d
Wall Stud
Cut access hole alongside stud and feed wires though hole.
Approximate Stud line behind wall
Wall
Screw
Bend wire to line |
|
up with access |
|
hole in plate. | Wall Mount Assembly |
8. | When the assembly is securely in place, loosen the hex |
| cap screw (turn |
| section back into a vertical position with the hex cap screw |
| at the top. Using the allen hex tool, turn the hex cap screw |
| clockwise to tighten. |
9.Remove the cover from the back of a speaker and carefully slide the speaker box bracket down into the V lock groove until it locks into place (see figure 7).
Slide the speaker onto the wall mount assembly.
Stage
Figure 5 — Install wall mount assembly
NExtron recommends that the wiring installation is performed by a professional audio equipment installer.
5. | Using compatible speaker wire (Extron recommends using |
| |
| speaker location by the most convenient and safe route. If |
| the wiring is to remain hidden behind the wall, follow the |
| stud to where the small access hole has been cut, and feed |
| about two feet of wire out through the hole into the room. |
| If necessary, bend the wire to align with the plate (see |
| figure 5). Secure the wire at various places to the stud, but |
| allow enough freedom of movement near to the hole for |
| connection to the speaker |
6. | Pull sufficient wire up through the holes in the rear plate |
| (see figure 6) to allow ease of connection to the speaker |
| after installation. |
| Pass the wires |
| through the plate |
| access hole. |
Figure 6 — Pass the wire through the plate
7.Place the wall mount assembly against the wall, aligning the plate holes with those drilled, and secure with appropriate hardware.
4SI 26 and SI 28 Speakers • Installation
Box bracket
Figure 7 — Install speaker onto the wall mount assembly
10.To adjust the angle of the speaker, carefully remove the Extron logo on the front of the speaker to expose the front locking access (see Figure 1, Item 3, for location). Insert the allen hex tool into the locking access, and slightly loosen the hex cap screw. Adjust the speaker to the desired angle (see figure 8), and torque the cap screw down clockwise until snug. The speaker will sit securely in the desired position. Install the Extron logo.
NThe Extron logo can be fitted either horizontally or vertically.
Turn clockwise to tighten.
Figure 8 — Adjust speaker and lock in place |
|
SI 26 and SI 28 Speakers • Installation | 5 |