Extron electronic manual Introduction, Mounting the SPA 12 AAP, Installation into an HSA

Introduction

The Extron SPA 12 AAP is a full-range speaker designed for installation within the enclosures of select HSA (Hideaway™ Surface Access) and Cable Cubby® Series products. It provides localized, near-field sound coverage for one or more participants at a conference table.

Mounting the SPA 12 AAP

The SPA 12 installs directly into the four-space AAP opening of various architectural frames; the Cable Cubby 300, 600, and 800 series; and the HSA 400, and 822 series.

Each SPA 12 AAP includes a rear enclosure and a factory installed magnet cap to secure it. These pieces enhance the quality of sound, but are not required for use.

Installation into an HSA 400

To install the SPA 12 AAP speaker into an Extron HSA 400 front panel, do the following. Several of the steps are summarized in figure 1, below.

1.Insert the provided polyester fiber foam into the rear enclosure.

10 Tighten (2) #4-40 Nuts	9 Tighten Lock Nut
w/ Captive Washers
(this side)	& Washer

2

Extron HSA 400

125

50 /60 Hz 0.5A

8 Back Can

Front Panel

Extron

SPA 12

Front Grill

SPA 12 AAP

HSA 400

4

Threaded

Standoff

Driver Mount Cap

1Polyester Fiber Foam

Gasket

6 Speaker Wire

5 Tighten (2) #4-40 Nuts

w/ Captive Washers (this side)

3 Remove (2) L-bracket Mounting Nuts

(this side only)

Figure 1 — Mounting the SPA 12 onto the HSA 400

2.Pass the speaker wire pair through the small hole on the side of the rear enclosure.

SPA 12 AAP Speaker • Installation Guide 1