Extron electronic setup guide TLP 710MV and TLP 710TV Setup Guide, Overview

TLP 710MV and TLP 710TV • Setup Guide

Overview

						:
				ANT					for
			T			.com
	IMPOR.				on		Series
			extr			710
		towwwTLP								.
						connecting
Refer					e				ce
								sour
	completebefor
the guide thepower
user			to
the	product

The Extron TLP 710MV (wall-mounted) and TLP 710TV (desk-mounted) TouchLink™ Panels provide simple and versatile configuration and control for a range of IP Link® control systems. Graphic and text objects are displayed on the screen. These objects have system control functions associated with them, and the touch overlay allows you to activate or regulate those functions.

These touchpanels communicate through an Ethernet connection to a configurable IP Link control processor. Video and audio input is provided by a twisted pair cable connected to an Extron MTP transmitter.

NOTE: The network output must be connected to a network switch, hub, or router that is connected to an Ethernet

LAN or the Internet. An Extron IP Link controller must also be connected to the same network. Suggested models include IPL T S series (for example, IPL T S4), IPL 250, IPL T CR48, IPL T SFI244, or IPCP 505.

Extron strongly recommends that power is provided by a Power over Ethernet (PoE) power supply.

This guide provides basic instructions for experienced installers to mount and perform initial configuration on the

TLP 710 series of touchpanels. Full instructions and reference material can be found in the TLP 710MV and TLP 710TV User Guide, which is available on the Extron website (www.extron.com).

Front Panel Features

gg

d d

		e	e
a
	Extron	a
b			Extron
		f b	f
c
		c
	Extron TLP 710MV		Extron TLP 710TV

AMotion Sensor — when no motion has been detected for a user-defined period of time, the unit goes into sleep mode. When motion is detected by the sensor, the screen display is restored and active.

BMicrophone — is located below the LCD screen.

CSpeaker — one, placed under the screen, on the left side of the panel, provides audible feedback for the user.

DProgrammable LEDs — one on each top corner can be programmed to provide system feedback. They light red or green and can blink or light steadily.

ELCD screen — has a 800x480 resolution with a touch overlay. Extron software is used to design and configure a graphic user interface to display buttons, text, or icons, which have user‑defined functions associated with them.

FConnection status LED — is unlit during normal operation. The LED blinks red if the connection to the IP Link controller is lost.

GLight Sensor — (can be seen only from above the unit) monitors ambient light level and adjusts screen brightness.

1