Table of Contents, cont’d
About this Guide
This guide contains instructions for mounting two different Extron computer interfaces and an adapter plate into FSR® floor boxes. The interfaces are standard RGB 460xi series and RGB 472xi series interfaces tailored to fit the FSR floor box.
The AAP 102 FSR adapter plate is a blank faceplate for the FSR floor box, to which any standard Extron AAP (Architectural Adapter Plate) can be mounted.
In this guide, the terms “FSR interface” and “Interface” are used interchangeably.
For information about operating and wiring the interface, refer to the RGB 400xi Series User Manual, Part
Installation Overview
CAUTION
Installation and service must be performed by authorized personnel only. These products must be used with UL approved electrical boxes.
Install the interface or adapter plate as follows:
1
Turn all of the equipment off. Make sure that the computer, the interface, and the output devices (projector/ monitor, speakers) are all turned off and disconnected from the power source.
2
3
4
5
6
7
Select the installation location and install the electrical floor box. Refer to the documentation that was included with the floor box.
Route the cables that connect to the rear of the interface (or the AAP(s) to be installed in the AAP 102 FSR adapter plate).
Set the gain and DIP switches (or the switch(es) on the rear of the AAP(s) to be installed in the AAP 102 FSR adapter plate). Refer to the RGB 400xi Series User Manual, Part
For the AAP 102 FSR adapter plate only, secure the
AAP(s) to the front of the faceplate.
Connect the video, audio, and power cables to the rear of the device. Refer to the RGB 400xi Series User Manual, Part #68-
Connect power cords and turn on the projector or monitor and audio device, the interface, and the computer.
ii | RGB 460xi/472xi/AAP 102 FSR Series • Table of Contents | RGB 460xi/472xi/AAP 102 FSR Series • Installation Guide | 1 |
