2.Before installing the canopy, the Upper and Lower Chimney Covers must be installed. The Upper Chimney Cover (ItemAin Figure 8) attaches using two screws provided (Item B in Figure 8). Install the Upper Chimney Cover. The Lower Chimney Cover rests on the top of the Canopy once it is installed. Install the Lower Chimney Cover. Use the wood block to hold the Lower Chimney while installing the canopy by inserting the wood block between the inside of the support and the Lower Chimney Cover.
FIGURE 8
3.The canopy (Item A in Figure 9) attaches to the support (Item C in Figure 9) by four bolts (Item B in Figure 9) located inside the canopy next to the duct opening. Lift the canopy and insert the bolts into the slots on the support. Tighten the four bolts. Due to the weight of the rangehood, two people should lift it to avoid injuries. Make sure that the bolts are properly seated in the slots and fully tightened.
FIGURE 9
!WARNING
DUE TO THE SIZE AND WEIGHT OF THIS RANGE- HOOD, THREE PEOPLE ARE REQUIRED TO INSTALL THE CANOPY. Two people must hold the canopy in place while the third person installs the bolts that attach the canopy to the chimney. The manufacturer assumes no responsibility for injury or damage caused by improper installations.
4.The electrical cable inside the chimney must be connected to the electrical coupling inside the canopy of the rangehood. The coupling is located behind the access panel (Item A in Figure 10) marked with a warning label. Open the access panel by removing three screws (Item B in Figure 10). Be careful not to drop the access panel as it is held in place only by these three screws. Once the access panel is removed, connect the electrical coupling (Items C & D in Figure 10). Inside the chimney, there is a circular guide for the cable to hold the electical cable in place. On the electrical cable, there is a rubber grommet that must be inserted into the guide. Once the coupling is connected and the cable secured in the guide, then the coupling must be hidden behind the access panel (Item E in Figure 10). The cable must pass through the square notch in the access panel.
FIGURE 10
5.Install the grease filters. If your installation is ductless, then you must install the charcoal filters before installing the grease filters. The two charcoal filters (Item B in Figure 11) fit into the opening in the canopy (Item A in Figure 11). Once the Charcoal Filters are in place, then install the Grease Filters (Item C in Figure 11).
FIGURE 11
6.Turn the power supply on. Turn on blower and
light. If the rangehood does not operate, check that the circuit breaker is not tripped or the house fuse blown. If the unit still does not operate, disconnect the power supply and check that the wiring connections have been made properly.
Version 02/02 - Page 6
