INSTALL THE RANGEHOOD
1.Remove the rangehood from the carton and place on a flat sur- face. Cover the surface to prevent accidental damage. Remove all parts including the backdraft damper and literature package before discarding the carton.
2.Place the round damper into the exhaust opening of the range- hood and press down as indicated in FIGURE 5. Use duct tape to secure if necessary.
FIGURE 5
3.The entire bottom of the rangehood must be removed for installation as indicated in FIGURE 6. Remove the grease filters USING TWO HANDS (one to hold the filter so that it doesn't fall on cooktop and one to turn the knob (A in FIGURE 7) by pulling the knob out and turning to the left.
FIGURE 6
4.Remove the grease filter divider (B in FIGURE 7) by first removing the plastic screw cover (C in FIGURE 7), then removing the phillips screw under the screw cover.
FIGURE 7
5.Remove the two philips screws (D in FIGURE 8). Remove the entire bottom of the rangehood by pushing your thumb into the side holes (E in FIGURE 8) and pulling the sides free from the rangehood.
FIGURE 8
6.Fix the rangehood to the cabinet or custom hood using the four spring loaded brackets, two on each side of the rangehood. Using a philips screwdriver or drill, tighten the adjustment screws (F in FIGURE 9) until the brackets adhere tightly to the surface.
7.IMPORTANT: There are 6 holes (G in FIGURE 9) for screws (not provided) to reinforce the rangehood to your cabinet or custom hood. Use screws appropriate for the size and type of materials of your cabinet or custom hood.
FIGURE 9
8.Replace the bottom of the rangehood and reinsert the grease filter divider and grease filters.
9.Remove the cover from the field wiring compartment with a phillips screwdriver. Feed the Power Supply Cable through the electrical knockout. Connect the Power Supply Cable to the rangehood cable. Attach the White lead of the power supply to the White lead of the rangehood with a
10.Connect the ductwork to the damper and seal all connections with duct tape.
11.Turn the power supply on. Turn on the blower and light. If the rangehood does not operate, check that the circuit breaker is not tripped or the house fuse blown. If the unit still does not operate, disconnect the power supply and check that the wiring connections have been made properly.
Version 10/05 - Page 7
