!WARNING
DUE TO THE SIZE AND WEIGHT OF THIS RANGEHOOD, THE SUPPORT MUST BE FIRMLY ATTACHED TO THE CEILING. For plaster or sheet rock ceilings, the support must be attached to the joists. If this is not possible, a support structure must be built behind the plaster or sheet rock. The manufacturer assumes no responsibility for injury or damage caused by improper installations.
ATTACH THE SUPPORT
1.Put a thick, protective covering over cooktop,
2.Determine and clearly mark with a pencil the center on the ceiling where the rangehood will be installed.
3.A template for
mounting the support is supplied in the carton with the support. Use this template to mark holes for support on the ceiling. The chimney must be disassembled
as indicated | in FIGURE |
|
5 to reveal the support. |
| |
Before disassembling |
| |
the chimney, | remove all | FIGURE 5 |
screws ( 3 ). |
|
|
|
| |
4.Determine and make all necessary cuts for the ductwork. Install damper when connecting ductwork. Install ductwork before mounting the support. The damper attaches to the inside bottom of the chimney support structure. It is necessary to attach your ductwork to this damper and run the ductwork inside the chimney support structure.
5.Determine the proper location for the Power Supply Cable as indicated on the template. Use a 1 1/4" Drill Bit to make this hole. Run the Power Supply Cable. Use caulking to seal around the hole. DO NOT turn on the power until installation is complete! Two knockouts are provided near the exhaust exit on the canopy. One is for the Power Supply Cable and one for an optional remote blower. Make sure that you use the correct knockout.
6.Attach the support to the ceiling. Make sure that the support is firmly connected to the ceiling. The height of the canopy can be adjusted by changing the length of the support.
Adjust the support length by loosening the four set screws (V in FIGURE 6). The bottom of the canopy will be approximately 10 1/4 inches below the bottom of the support. Make sure that all four set screws are firmly tightened before attaching the canopy.To prevent damage, the support must be adjusted BEFORE attaching the canopy.
FIGURE 6
INSTALL THE RANGEHOOD
1.Remove the unit from the carton and place on a flat surface for assembly. Cover the surface to prevent accidental damage. Remove all parts including the mounting hardware before discarding the carton.
2.Remove the grease
filters and set aside. The |
|
grease filters are removed by |
|
pressing the handle in front |
|
of the filter as indicated in |
|
FIGURE 7. When replacing, |
|
make sure the filters are |
|
properly positioned with the |
|
handles visible in front. | FIGURE 7 |
3.Remove the cover from the field wiring compartment. Remove the wiring electrical knockout using a flat-blade screwdriver.
4.The canopy attaches
to the support by four bolts located next to the duct exhaust opening. Loosen the four bolts so that there is approximately 1/4" space between the bolt head and the canopy. FIGURE 8 shows how the canopy attaches to the support.
FIGURE 8
5.Lift the canopy and insert the bolts into the slots on the support. Tighten the four bolts. Due to the weight of the rangehood, two people should lift it to avoid injuries. Make sure that the bolts are properly seated in the slots and fully tightened.
6.Connect the Power Supply Cable to the rangehood. Attach the White lead of the power supply to the White lead of the rangehood with a
If your installation uses an optional remote blower, connect the wiring cable for the blower. DO NOT CONNECT THE
REMOTE BLOWER DIRECTLY TO THE POWER SUPPLY CABLE IN THE FIELD WIRING COMPARTMENT.
7.Replace the wiring compartment cover and grease filters.
Version 09/05 - Page 5
