Manual Operation
The Standby Switch (Switch 1) must be first turned ‘ON’ and the AUTO/MAN (Switch 2) switch set to ‘MANUAL’ to operate the manual controls - see Fig 6.
Note : When the fire is put in Manual mode the first time the flame effect will come on indicated by the Bottom neon coming on for 3 seconds - see Fig 7.
MAN AUTO ON OFF
Manual Controls
Fig. 6
Setting | Operation | Indication |
Flame Effect only | Press the ‘ I ’ button (Switch 3) | Top Neon |
Flame Effect & Heat On | Press the ‘ I ’ button again (Switch 3) | Bottom Neon |
Neons for |
indicating |
operation level |
Fig. 7
To go to the previous settings press the ‘ O ‘ button (Switch 3).
To increase or decrease the brightness of the flames, use the dimmer button (Switch 4). You can have any setting between full brightness and the flames totally off. The heat setting will remain the same.
To turn off the power the Standby Switch (Switch 1) must be turned ‘OFF’.
Note : Every time that manual mode is selected the previous light and heat settings come on automatically.
