Faber SP4 dimensions Lamp Replacement

Lamp Replacement

WARNING – ALWAYS DISCONNECT FROM THE POWER SUPPLY BEFORE REMOVING LAMPS.

The front surround will need to be removed in order to change lamps.

Warning -The front surround is heavy and easily damaged !.

The front surround is fixed with 4 spring loaded pins and is supported at the top by the chassis.

To gain access to the lamps please apply the following proce- dure:

While holding the surround by its sides with both hands, care- fully pull forwards the surround at the bottom until the pins detach from the clips (see Fig. 9).

For access to the bottom bulbs, carefully slide the flexible ro- tisserie to one side ensuring that the rubber grommets are not lost (see Fig 11).

Grommet

Rotate flexible Rotisserie out of position

Fig. 11

Spring clip

Holding Pin

Fig. 9

When the bottom holding pins are undone, carefully pull for- wards at the top until the top pins detach and then lift the surround up and out (see Fig. 10).

Chassis bracket

Chassis

Spring clip	Holding
	Pin

Fig. 10

Remove the defective lamp by unscrewing it (see Fig 12). Replace with a 60W E14 SES clear candle bulb, rotating it. Take care not to over tighten the bulb.

Flexible Rotisserie rotated out of position

Fig. 12