EN |
| 6 / |
|
|
|
• DIRECT EVACUATION OF WATER CONDENSER
To avoid having to empty the collection tank every time you use the appliance, you have a kit (*) for removing the water from the condenser directly into the drain (hose and deflector). To fit this :
— Take off the existing pipe and push it inside the appliance (Fig. 13).
— Clip the deflector with the top of the pump (Fig. 14).
— Connect the hose from the kit to the end connector
EN 6 / USER-MAINTENANCE INSTRUCTIONS
• CLEANING THE CONDENSER
Important : |
|
The condenser must be cleaned twice a |
|
month. |
|
Important : |
|
Unplug the power cable from the socket | Fig. 18 |
before cleaning the condenser. | |
— Open the grill at the front of the appliance. |
|
on the appliance (Fig. 15)
Fig. 13
— Release the condenser (Fig.18). |
— Remove it carefully (Fig.19). |
You can connect the other end of the hose either :
-To a ventilated trap (Fig. 16).
-Or a sink trap (Fig. 17).
When connecting to a trap, you must remove the fil- ler plug. Then press home the rubber tip. If neces- sary, add a clamp connection (Fig. 17).
Fig. 14 |
— Remove any fluff from the condenser. |
|
|
|
— Clean it with water only under the tap (Fig.20). |
|
|
|
— After cleaning, ensure that none of the tubes are | Fig. 19 | ||
“blocked” and that the fins are clean. | |||
— Rub it superficially. |
|
|
|
|
|
| |
— |
|
|
|
the grill. |
|
|
|
|
|
| |
|
|
|
|
Important :
The deflector must be positioned before the drain hose connection to avoid any water splashes when taking off the hose.
Fig. 20
Important :
When refitting the condenser, ensure that it is pushed in firmly right to the back of its hou- sing when locking it in
Remarks :
(*)This kit is provided with the appliance or is available near your
Hose
Deflector
Insert
Fig. 15
90 cm maxi |
Fig. 16 |
• CLEANING THE APPLIANCE
Advice :
To clean the control panel, the access to the drum and the casing, use only a sponge or a damp cloth and some soapy water.
—Ensure that there is no fluff accumulating round the dryer.
—Clean the door seal with a damp cloth.
—Clean the filter housing with your vacuum cleaner once a year.
You should not use, under any circumstances (Fig
21):
Fig. 21 |
Fig. 17
18
—Abrasive powders
—Metal or plastic sponges
—
19
