ASSEMBLING THE CADDY
Assembling the Caddy
Your vacuum cleaner requires some assembly. Ensure that all parts listed on the “Parts and Components” page are included in the packaging.
Tools Required for Assembly
Phillips Screwdriver | Wrench |
(not included) | (included) |
1.Assemble the caddy frame first. Parts required for this step:
-caddy support (left)
-caddy support (right)
-rear caddy frame and front caddy frame
-4 Bolt / Lock Washer / Locking Nut (Fig. 1)
Right | Left | |
Support | ||
Support | ||
|
Rear Caddy
4 Bolts Frame
4 Lock Washers
4 Locking Nuts
Front Caddy
Frame
Notches
Open Side Up
Fig. 1
6.Repeat with the left support securing to the caddy frame.
7.Ensure all fastenings are tight using a Phillips screw driver (not included) and the wrench (included).
8.Slide the axel through the holes in the rear frame. (Fig. 4)
9.On the outside side of the axel, place a washer in the groove nearest to the frame. (Fig. 3)
| Rear Caddy |
| Frame |
Front Caddy | Axel |
Frame |
|
| Fig. 3 |
| Flat Washer |
10.Slide a rear wheel onto each side of the axel.
11.Place a flat washer against the outside of each wheel onto the axel. Repeat on the opposite side wheel.
12.Secure each wheel with a cotter pin placed in the hole and wrapped around the axel to secure the wheel to the axel. (Fig. 4)
Flat Washer
2.Make sure the notches on the caddy frame pieces are sitting open side up. Fit the front caddy frame into the rear caddy frame. (Fig. 2)
3.Place the right support on the inside of the right side of the caddy frame, aligning all openings.
Note: The front caddy support will have to be squeezed to join with rear caddy support.
4.Secure the right support with bolt and lock washer. [C]
5.On the inside place a washer onto the bolt and fasten with locking nut [C]. (Fig. 2)
Flat Washer
Axel
Cotter Pin | Fig. 4 |
|
Cotter Pin
Left Support
(inside)
Rear Caddy
Front Caddy (outside)
(center)
13.Assemble the bracket cover [I] on the caster bracket and then use the screw [F] to fasten. (Fig. 5)
Fig. 5
Fig. 2
3
