ASSEMBLING THE CADDY
Assemble the Vacuum to the Caddy
1.Make sure that the hose intake is facing forwards and the wheels are at the rear of the unit. Using the handles on the canister, carefully lower it onto the frame aligning the canister edge with the notches in the frame. (Fig. 6)
Notches on Caddy
NotchesNotches
Fig. 6
2.To attach the canister to the handle supports, align the canister brackets on each side of canister with the supports. (Fig. 7)
3.With the clamp assembly tabs facing downwards, slide a clamp assembly onto the right and left caddy support. (Fig. 7)
Clamp
Assembly
Tabs
6.To insert the caddy handle onto the right and left caddy supports, fit the ends of the caddy handle into the openings of the left and right caddy supports and push down until the caddy handle clicks into place. (Fig. 9)
Fig. 9
Filter Assembly
This wet/dry vacuum requires different filter assembly for wet or dry
Dry | Wet |
Filter Cartridge | Dust Bag |
| Foam Filter |
|
|
|
|
Fig. 10 |
|
| Fig. 11 |
Fig. 7
Canister Bracket
4.Place the clamp assembly tabs onto the canister brackets on each side of the canister.
5.Tighten the clamp assembly by turning the hand nut clockwise until it is secured on the supports. (Fig. 8)
Hand Nut
For Dry
1.To assemble the filter for dry pick up, turn the filter holder upside down on a level surface. (Fig. 12)
2.Place the filter cartridge onto the filter holder, ensuring that the locking tab inside the filter cartridge is aligned with the slot on the filter holder and turn the locking knob until it stops. (Fig. 13)
Important: Do not operate the vacuum without the filter cartridge and dust bag in place for dry
Fig. 12
Locking
Knob
Filter
Cartridge
Fig. 13
Fig. 8
4