Fantom Vacuum FM1705K Nettoyage DU Plateau À Poussière, Charging the Cordless Hand Sweeper

NETTOYAGE DU PLATEAU À POUSSIÈRE

Pour un meilleur rendement, videz le plateau après chaque usage.

1. Retirez le plateau tout droit hors du côté de la balayeuse (Fig. 2)

Fig. 2

2.Videz le contenu du plateau (Fig. 3). Si vous le désirez, rincez le plateau à l’eau pour le nettoyer mais séchez-le complètement avant de le remettre dans la balayeuse.

Fig. 3

3.Remettez le plateau dans la balayeuse.

4.De temps à autre, retirez le couvercle transparent de la brosse et retirez toute accumulation de peluches, de cheveux ou de fibres sur la brosse rotative. Pour enlever le couvercle transparent, agrippez le couvercle à partir du bas, tirez-le vers l’extérieur jusqu’à ce qu’il sorte des fentes du bas et de languettes situées dans le haut de la balayeuse (Fig. 4, Fig. 5).

Fig. 4 Fig. 5

AVERTISSEMENT: Évitez de mettre la balayeuse

accidentellement en marche pendant son nettoyage. Ne nettoyez pas la balayeuse pendant qu’elle se recharge.

CHARGING THE CORDLESS HAND SWEEPER

1a. Connect the charger plug to the charging jack or hole on the back of the hand sweeper. Plug the the charging adapter into the wall outlet. (120V.,60Hz.) Use only the charger supplied by the manufacturer, rated output DC 5.5 V, 100mA. (Fig. 6)

OR

1b. Connect the charger plug on the charging jack of charging stand (optional). (Fig. 7). Plug the charging adapter into the wall outlet(120V., 60Hz). Use only charger provided, place the unit in the charging stand.

2.This cordless hand sweeper is powered by Ni-Cd batteries. Before first use, they must be charged for a minimum of 24 hours. When the batteries are charging, charging light indicator on the top of the unit will illuminate to tell you that the unit is charging.

3.Once the batteries are fully charged, the cordless hand sweeper will run for approximately 20-25 minutes before recharging is required.

4.When recharging the unit, the "On/Off" switch must be in the "OFF" position.

5.The charging light indicator on the top of the sweeper will illuminate to indicate that the sweeper is properly charging.

6.To recharge, repeat step #above. Charging times will vary depending upon the amount of usage between charging cycles.

Wall Mounting Bracket (Optional)

1.Make sure that the intended wall area for the wall mounting bracket to be drilled is free from any hidden electrical wires,

2.	water pipes and gas lines.
	Select an appropriate place	Fig. 6
	close to a wall power outlet
3.	(120V., 60 Hz).
	Do not mount near direct sunlight, near a heat source or
	outdoors.		Fig. 7
4.	Select an appropriate drill type for the material to be drilled.
5.	Carefully measure and mark the location of all bracket holes
	and then drill holes and screw the wall mounting bracket
	onto the wall.

NOTE: If, when you place the sweeper to recharge and the charging indicator light does NOT illuminate, then press the On/Off button once to turn the sweeper off. The charging indicator light should now light up.

NOTE: Peak performance may only be realized after the unit has been charged and discharged two (2) or three (3) times.

IMPORTANT: To maintain peak performance of your cordless hand sweeper, it is recommended that the unit be fully discharged, then completely re-charged at least once a month.

CAUTION

• Use only with the battery pack supplied with the unit.

• Do not attempt to remove the battery pack from the unit to charge it.

• Never attempt to throw the battery pack or unit into a fire or incinerate it.

• Do not attempt to remove or damage the battery casing.

• Battery must be recycled or disposed of properly at the end of it's service life.

20 5