Fantom Vacuum FM430K owner manual Using The Unit As A Hand Vacuum, Cleaning With the Hose

OPERATING INSTRUCTIONS

OPERATING INSTRUCTIONS

Warning: Always unplug from electrical outlet before opening the dust cup (container).

Note: HEPA dust cup filter must be used when operating the hand vacuum.

Using The Unit As A Hand Vacuum

1.Insert the dusting brush/hose connector into the brush chamber exhaust port. Lock the flexible hose in place by clipping the hose into the hose holder. (fig. 1)

Fig. 1

Cleaning With the Hose

To use the hand vacuum with only the hose and the dusting brush or crevice tool:

1.Rotate the brush cover by pushing on the brush cover release button until it clicks in place. (fig. 2)

2.Remove the flexible hose from the brush chamber exhaust port and take the hose out from the hose holder. (fig. 3)

Fig. 2

3.To use the flexible hose with the dusting brush, hold the hose in one hand and with the other, pull out the dusting brush and turn clockwise to lock in place. (fig. 4)

Fig. 4

3.To use the flexible hose with the crevice tool, make sure that the brush is in the storage position and insert the crevice tool into the opening of the hose. (fig. 5)

Fig. 5

CAUTION: The Hand Vacuum is a very powerful unit. Make sure that you hold it firmly, otherwise it can slip out of your hand and cause injury.

Cleaning & Changing the HEPA Dust Cup Filter

Warning: Always unplug the unit from electrical outlet before opening the Dust Cup (container).

Important: Do NOT use the HEPA filter cartridge without the debris screen in place.

Warning: After each Use - Always remove the Filter Debris Screen from the HEPA Dust Cup Filter, then vigorously “TapClean” HEPA Filter until no more dust can be removed.

IMPORTANT, Please Note : The “TapClean” HEPA Dust Cup Filter & Debris Screen will stop most of the tiniest dust particles and airborne allergens from re-entering the air you breathe. In fact it stops 99.97% of all particles as small as

0.3microns - many times smaller than a human hair!!! Because of this incredible filtration performance, the HEPA Dust Cup Filter will quickly accumulate, inside the white filter folds, many fine dust particles that are difficult to see but which will eventually block or reduce your suction power - if not cleaned properly. Clean the HEPA Filter and Debris Screen after each use as described in this section.

1.To remove the dust cup (container), hold the unit in the upright position to prevent the dust from falling out of the dust cup. (Fig. 6)

Fig. 6

2.To open the Dust Cup (container), push button and remove the Dust Cup (container ). (Fig. 7)

Dust cup release button

Fig.7

3.Rotate the lower dust cup clockwise to separate it from the filter chamber. Empty and clean the dust cup. (fig. 8)

Fig.8

FilterDust

Chamber Cup

4.Remove the HEPA Filter from the filter chamber. (fig. 9)

Filter

HEPA Chamber

Filter

Fig. 9

5.Separate the debris screen from the HEPA filter cartridge by grasping the debris screen with one hand and the filter frame with the other and pull apart. (fig. 10)

Debris

Screen

HEPA

Filter

Fig. 10

Fig. 3

4

5