Delta 32-350 Additional Safety Rules For Boring Machines, Unpacking and Cleaning

ADDITIONAL SAFETY RULES

FOR BORING MACHINES

1.WARNING: Do not operate your boring machine until it is completely assembled and installed according to the instructions.

2.IF YOU ARE NOT thoroughly familiar with the oper- ation of boring machines, obtain advice from your super- visor, instructor, or other qualified person.

3.MAKE CERTAIN the machine is fastened to a sup- porting surface.

4.NEVER turn the boring machine “ON” before clearing the table of all objects (tools, scrap pieces, etc.).

5.ALWAYS keep hands, fingers, and hair away from rotating bits.

6.DO NOT attempt to bore material that does not have a flat surface, unless suitable supports are used.

7.ALWAYS support work material firmly against fence.

8.ALWAYS use clamps or fixtures for small or narrow work stock.

9.MAKE SURE that drill bits are not damaged and are properly secured before operating.

10.DISCONNECT and lock out machine from power source before making repairs or adjustments.

11.NEVER start the boring machine with the drill bits pressed against the workpiece.

12.NEVER perform layout, assembly, or set-up work on the table while the machine is operating.

13.ADJUST the depth stop before operating.

14.ALWAYS stop the machine before removing scrap pieces from the table.

15.WARNING: For your own safety, don’t wear gloves when operating the machine.

16.SHOULD any part of your boring machine be missing, damaged, or fail in any way, or any electrical component fail to perform properly, shut off switch and remove plug from power supply outlet. Replace missing, damaged, or failed parts before resuming operation.

17.ADDITIONAL information regarding the safe and proper operation of this product is available from the National Safety Council, 1121 Spring Lake Drive, Itasca, IL 60143-3201, in the Accident Prevention Manual for Industrial Operations and also refer to the American National Standards Institute ANSI 01.1 Safety Requirements for Woodworking Machinery and the U.S. Department of Labor OSHA 1910.213 Regulations.

UNPACKING AND CLEANING

Carefully unpack the machine and all loose items from the shipping container. Remove any protective coating from the machined surfaces of the boring machine. This coating may be removed with a soft cloth moistened with kerosene (Do not use acetone, gasoline or lacquer thinner for this purpose). After cleaning, cover all unpainted surfaces with a good quality paste

4