Care and Cleaning
| CLEANING THE DOORS |
GB | (model: 50HGP) |
| |
| Take particular care not to damage the inner |
| |
| surface of the door inner glass that is coated |
| with a heat reflective layer. Do not use |
| scouring pads, or abrasive powder,which will |
| scratch the glass. Ensure that the glass |
| panel is not subjected to any sharp |
| mechanical blows. |
| Stubborn stains can be removed by using a fine |
| steel wool soap pad. For slight soiling theinner glass |
| panel may be cleaned, while still warm, without |
| removing it from the door. Aftercleaning, rinse and |
| dry with a soft cloth. |
| SIDE OPENING DOORS |
| Cleaning the door glass is the same as the |
| drop down doors, except take care to |
| support the weight of the inner glass when |
| removing and refitting. |
| DROP DOWN DOORS |
| Wipe over the outer door glass panels with a cloth |
| wrung out in warm soapy water, then after wiping |
| with a cloth wrung out in clear water, dry with a soft |
| clean cloth. Ensure that glass doors are not |
| subjected to any sharp mechanical blows. |
| Glass Inner Door Panel (where fitted) – open |
| the door fully and unscrew the two screws securing |
| the glass panel, taking care not to allow the glass to |
| fall. The glass panel may now be washed at the |
| sink. Stubborn stains can be removed by using a |
| fine steel wool soap pad. Ensure the glass panel |
| is not subjected to any sharp mechanical |
| blows. Take particular care not to damage the inner |
| surface which is coated with a heat reflective layer. |
| After cleaning, rinse and dry with a soft cloth. For |
| slight soiling the inner glass panel may be cleaned, |
| while still warm, without removing it from the door. |
| Warning: Oven must not be operated with inner door |
| glass removed. |
| Take care during cleaning not to damage or distort |
| the door seals. Do not lift the door seal from the |
| oven chassis, if necessary remove the seal by |
| carefully unhooking the corner clips. |
| Take care that the rating label edges are not lifted |
| during cleaning, and furthermore that the lettering is |
| not blurred or removed. |
BURNER MAINTANANCE INSTRUCTIONS
Before cleaning the burners ensure the appliance is switch off and isolated from the electriacl supply and the appliance is cold.
MAIN OVEN
When the main oven is used regularly, its burner is susceptible to being covered with grease and dirt.
This might result in problems with the burner’s ignition as well as the uneven or disappearing flame.
To solve the problem clean the burner with a small amount of water- diluted cleaner (e.g. CIF) using a small brush (e.g. a toothbrush). After cleaning wipe the burner with a cloth to remove the detergent waste and let it dry for at least 2 hours.
Before cleaning, to reach the burner easily unscrew the two screws and take off the shield protecting the burner (in main oven burner only).
WARNING!
1.Brush the burner in the directions indicated below.
2.DO NOT
TOP OVEN/ MAIN OVEN
When the Top oven/grill is used regularly, its burner is susceptible to being covered with grease and dirt.
This might result in problems with the burner’s ignition as well as the uneven or disappearing flame.
To solve the problem clean the burner with a small amount of water- diluted cleaner (e.g. CIF) using a small brush (e.g. a toothbrush). After cleaning wipe the burner with a cloth to remove the detergent waste and let it dry for at least 2 hours.
WARNING!
1.Brush the burner in the directions indicated below.
2.DO NOT
PLEASE PHONE US TO REGISTER YOUR APPLIANCE AND ACTIVATE YOUR PARTS GUARANTEE ON 08448 24 24 24
20
