Hotpoint HUG 52X, HUG 52P, HUG 52K, HUG 52G, 50HGP Problem, Check, Hotplate burner

Cooking Results Not Satisfactory? / Something Wrong with your Cooker?

Problem		Check
Grilling		GB
		Ensure that the grill pan is positioned centrally below
Uneven cooking front to
back		the grill element.
Fat splattering		Ensure that the grill is not set to too high a temperature.
Oven Baking		Ensure that the oven shelves are level by using a spirit
Uneven rising of cake		level on the rod shelf and adjusting, using suitable
		packing e.g. wood, under the feet of the appliance. This
		should be checked both left to right and front to back.
		Ensure that the food is positioned centrally in the oven.
Sinking of cakes		The following may cause cakes to sink:
		1. Cooking at too high a temperature.
		2. Using normal creaming method with soft margarine.
Over/Under cooking		Refer to the cooking times and temperatures given in
Fast/Slow cooking		the oven temperature charts, however, it may be
		necessary to increase or decrease temperatures by
		10°C to suit personal taste.
		Do not use utensils greater than 2Ľ ins in height.
PROBLEM		CHECK
Burner will not light:		If all burners fail to ignite:
		Check that sparks appear at the burners; a clicking
		noise should be heard.
		If not;
		Check that the electricity supply is turned on.
		If the electricity supply has failed, you can only
		use the hotplate burners, which can be lit by
		a match.- DO NOT USE THE GRILL OR OVEN(S)
		WITHOUT AN ELECTRICAL SUPPLY BEING
		CONNECTED TO THE COOKER
		If only one burner fails to ignite:
		Check that the burner is dry and that spillage of food
		or cleaning fluid remains are not affecting the ignitor
Hotplate burner		or burner ports.
		Clean away any debris with a dry nylon brush such as
		an old toothbrush. If a wire wool pad has been used
		for cleaning around the burner ensure the ignitor is
		free from any stray strands. Any water on the burner
		should be dried with a cloth or kitchen towel.
		On the hotplate make sure that all the burner parts
Burner ports	Ignitor	are correctly seated.
		Hob burner ignites, but goes out when
		control knob is released:
		Models with Hob Gas Burner Safety Devices to Prevent Leaks*
HOB GAS BURNER
SAFETY DEVICE
		These models can be identified by the presence
		of the device itself. Since the hob burners are equipped
		with a safety device, you must hold the control knob for
	ELECTRONIC	about 3-7 seconds after the burner has been lighted to
	LIGHTING DEVICE
		allow the gas to pass until the safety thermocouple has
		heated.
		*(only available on certain models).

PLEASE PHONE US TO REGISTER YOUR APPLIANCE AND ACTIVATE YOUR PARTS GUARANTEE ON 08448 24 24 24

21