Hotpoint HUG 52P, HUG 52X, HUG 52K, HUG 52G, 50HGP Gas connection, Disposing of the appliance

Installation

Moving the Cooker

Fig. B		Fig. C
Gas connection
		The cooker should
		be connected to the
	HOT PARTS	gas-supply by a
		gas safe registered
		installer. During
	mm	installation of this
		product it is
	600
		essential to fit an
		approved gas tap to
		isolate the supply
		from the appliance

for the convenience of any subsequent removal or servicing. Connection of the appliance to the gas mains or liquid gas must be carried out according to the prescribed regulation in force, and only after it is ascertained that it is adaptable to the type of gas to be used. If not, follow the instructions indicated in the paragraph headed “Adaptation to different gas types”. In the case of connection to liquid gas, by tank, use pressure regulators that conform to the regulation in force. The gas supply must be connected to the left of the appliance. Be sure that the hose does not pass through the rear of the cooker touching hot parts.

!make sure the supply pressure conforms with the values shown in the table entitled “Caracteristics of the burners and nozzles”.

When the cooker is installed between cabinets (recessed), the gas connection must be effected by an approved flexible hose with bayonet fitting

(BS 669 Current Edition). The gas inlet for the cookers is a threaded G 1/2 gas female fitting .

Connecting the gas supply

GB

To make the connection, a flexible hose should be used corresponding to the current gas regulations which are:

•the hose must never be at any point in its lenght in contact with the “hot” parts

of the	cooker;
•	the hose must never be longer than 1,5
metre;
•	the hose must not be subject to any tension

or torsional stress and it must not

have anyexcessively narrow curves or bottlenecks;

•the hose must be easy to inspect along its entire length to check its condition;

•the hose must always be in good condition, never attempt to repair.

!the installation must comply with gas safety (installation and use) regulations 1984. In all cases for the above, by low, a qualified, gas safe i approved engineer must be called for installation.

Disposing of the appliance

When disposing of the appliance please remove the plug by cutting the mains cable as close as possible to the plug body and dispose of it as described above.

Adapting the cooker to different types of gas

In order to adapt the cooker to a different type of gas with respect to the gas for which it was produced (indicated on the label attached to the lid), follow these steps:

a)replace the hose holder mounted on the appliance with that supplied in the bag of “cooker accessories”.

b)Replacing the burner nozzles on the hob:

•remove the grids and slide the burners from their housings;

• unscrew the nozzles using a 7 mm socket

spanner, and replace them with nozzles for

the new type of gas

(see table 1 “Burner and nozzle characteristics”).

•replace all the components by

repeating the steps in reverse order.

PLEASE PHONE US TO REGISTER YOUR APPLIANCE AND ACTIVATE YOUR PARTS GUARANTEE ON 08448 24 24 24

5