NovaJet 500/630/700 Series Service Manual
4.Using a cotton swab dampened with water, wipe the seals and the rubber wiper in the service station until no more ink residue or dust can be removed.
5.With a dry swab, wipe all moisture from the seals and wipers.
6.Close the lid and reconnect the power cord and interface cable.
7.If the service station is filling with ink or very dirty it can be removed and rinsed under warm water. To remove, pull the tab on the right side of the service station and lift out. Wash, dry thoroughly and replace by placing the left side in first then pushing down on the right side until the tab locks it in place.
Slide Shaft Cleaning
CAUTION
Use only NovaKlean™ or isopropyl alcohol on the slide shaft of the printer. Damage to the stainless steel slide shaft may result if cleaned with water and not completely dried off.
Printer problems can be caused by an accumulation of dirt or other contamination on the slide shaft. This contamination may lead to drag on the carriage. Extreme drag results in a “carriage axis failure” fault and will stop the carriage motion. These problems may be eliminated by maintaining and cleaning the slide shaft at intervals determined by the environmental conditions. Do not use any lubrication.
To clean the slide shaft:
1.Turn the printer OFF. Disconnect the power cord and interface cable.
2.Raise the printer lid.
3.Moisten a clean cloth or paper wipe with NovaKlean™.
MAINTENANCE
Maintenance
