Kodak 700, 630, 500 service manual Service Stepper Station Motor Foam Block LEG Harness

NovaJet 500/630/700 Series Service Manual

6.Reaching inside the Fan Exhaust hole under the Platen, position and secure the Fan Assembly(ies) using a #2 Phillips screwdriver.

7.Reinstall the Fan Exhaust Assembly(ies) using a #2 Phillips screwdriver.

8.Install the Lower Drive Roller Assembly support brackets using a #2 Phillips screwdriver.

9.Install the Center Support Bracket. Insert the Platen Plug.

10.Reinsert the right Foam Block. Make sure that the Stepper Motor and Fan(s) cables are exiting out of the back corner of the Foam Block. See Figure 5-27. The Foam Block is positioned between the Stepper Motor and the Servo Motor. Make sure it is not tilted at an angle.

SERVICE STEPPER

STATION MOTOR

FOAM

BLOCK

P/O LEG HARNESS

Figure 5-27. Inside Platen, Right Side.

ASSEMBLY/ DISASSEMBLY

Assembly\Disassembly 5-49