NovaJet 500/630/700 Series Service Manual
Install the Media Take-Up and Feed Motors
1.Using a #1 Phillips screwdriver, install the three screws, washers, and lock washers that secures the motor to the motor mount.
2.Install the motor gear to the motor. Secure with a C clamp.
3.Insert the motor, motor mount, and motor gear subassembly into the back of the Cradle Idler. Tilt the subassembly slightly while installing to align the motor gear with the opening on the top of the Cradle Idler.
4.Screw in the screw and washer that secures the motor mount to the Cradle Idler.
5.Attach the tension spring to the post on the Cradle Idler.
6.Position the Cradle Idler assembly in front of the hole in the leg assembly. Attach the wire connectors to the motor (red to the positive terminal, black to the negative terminal.)
7.Insert the Cradle Idler Assembly into the leg and secure with four screws.
Remove the Media Drying Fans
1.On the left side of the drying fan assembly is a black wingnut used to adjust the position of the fan assembly. Remove the black wingnut.
2.Disconnect the drying fan assembly leads from the printers leg assembly by squeezing the sides of the connector to release the quick disconnect latches.
3.Lift the entire drying fan assembly off of the printer.
