NovaJet 500/630/700 Series Service Manual
4.Reinstall the Power Supply Bracket using four screws.
5.Insert and hold the Power Supply into place while securing it with four screws. Torque to 15
6.Reconnect the Power Supply to the AC Entry Module by reattaching the quick disconnect connection. Push the quick disconnect assembly behind the Power Supply Bracket and out of sight.
7.Perform steps 1 through 14 of the Install the MPCB procedure to install the MPCB.
8.Perform steps 4 through 10 of the Install the Left, Top, and Right Covers procedure to install the Right and Top Covers.
Remove Servo Motor
1.Perform steps 1 through 9 of the Remove the Left, Top, and Right Covers procedure to remove the Top and Right Covers.
2.Perform steps 3 through 13 of the Remove the MPCB (Main Printed Circuit Board) procedure to disconnect all connectors from the MPCB.
3.Reach between the Power Supply Bracket and the AC Entry Module and carefully pull out the quick disconnect assembly attaching the Power Supply input to the AC Entry Module. Disconnect the Power Supply input from the AC Entry Module.
NOTE
The following procedure will leave the MPCB and Power Supply still attached to the Power Supply Bracket. For this procedure there is no reason to remove these assem- blies from the Power Supply Bracket.
4.Using a #2 Phillips screwdriver, remove the screw securing the ground strap from the MPCB to the side plate.
5.Using a #2 Phillips screwdriver, remove the four screws securing the Power Supply Bracket to the Right Baseplate. Remove the Power Supply Bracket.
