Kodak 700, 630, 500 service manual Remove the Keypad and Display

NovaJet 500/630/700 Series Service Manual

Applying too much torque to the lower screws can cause the mounts for the standoffs on the cover to break, re- quiring a replacement of the cover.

8.Using a #2 Phillips screwdriver, secure the Right Cover with two screws located on the left side (torque to 15 in-lbs) and three located under the baseplate (torque to 8 in-lbs.)

To install the Top Cover:

9.Insert the pin located on the right side of the Top Cover into the corresponding hole on the Right Cover Assembly.

10.While depressing the retracting stop assembly on the left side of the Top Cover, lower the left side of the Top Cover into position and secure it to the Left Cover Assembly by releasing the retracting stop assembly.

Remove the Keypad and Display

1.Perform steps 1 through 9 of the Remove the Left, Top, and Right Covers procedure to remove the Top and Right Covers.

2.Turn the Right Cover Assembly over and with a 1/4” socket or wrench, remove the four kepnuts securing the ESD Shield and ground connections. See Figure 5-4. Remove the ESD Shield.

3.With a 1/4” socket or wrench, remove the four standoffs and washers that secure the LCD Display Assembly to the Keypad. Remove the Display Assembly.

ASSEMBLY/ DISASSEMBLY

Assembly\Disassembly 5-7