NovaJet 500/630/700 Series Service Manual
e.Turn the Carriage Assembly over and insert the Paper Sensor flex cable into the connector at J3.
f.Push both sides of the connector lock shut at the same time.
2.To install the Encoder Sensor:
a.Turn the Carriage Assembly so that the bottom side of it is facing up.
b.Push down on the plastic clip and slide the back of the Encoder Sensor over it.
c.Push the Encoder Sensor in past the ridges until the Encoder Sensor snaps into place.
d.Turn the Carriage Assembly over and insert the Encoder flex cable into the connector at J2.
e.Push both sides of the connector lock shut at the same time.
3.Perform the Carriage Assembly, Carriage Belt, and the Frame Tensioner Reinstallation procedures to reinstall the Carriage Assembly.
Replacing the Carriage Bushings
1.If there is not enough space on both sides of the Slide Shaft to remove the Carriage bushings, perform the Carriage Assembly, Carriage Belt, and the Frame Tensioner Removal procedures to remove the Carriage Assembly from the Slide Shaft.
