Kodak 630, 500, 700 service manual Install the Ink Delivery System

NovaJet 500/630/700 Series Service Manual

4.With a flathead screwdriver, press the Carriage Cover (p/o the Ink Delivery System) tab located in the upper slot on the left side of the Carriage Assembly. See Figure 5-12. Lift up on the front left side of the Carriage Cover until it comes part way off of the Carriage Assembly. Then lift up on the front right side of the Carriage Cover and move the Carriage Cover slightly to the left so that the back of it clears the Back Support Bracket.

5.Disconnect the Ink Delivery System Bracket from the Left Sideplate using a #2 Phillips screwdriver.

6.Carefully slide the Ink Delivery System out of the printer.

Install the Ink Delivery System

1.Secure the Ink Delivery System Bracket to the Left Sideplate using two screws.

2.Position the Ink Delivery System into the Support Bracket so that it is easier to orient the Carriage Cover portion of the system over the Carriage for reinstallation.

3.Reattach the Chain Support Bracket to the Rear Support Bracket.

4.Position the Carriage Cover over the Carriage Assembly. Depress the two tabs on each side of the Cover and lower the Assembly onto the Carriage until it snaps into place.

5.Move the Carriage Assembly over the Chain Support Bracket and adjust the position of the Chain Support Bracket to ensure that there is a 0.10 inch clearance between the top of the Chain Support Bracket and the bottom of the chain assembly that is attached to the Carriage Cover on the Carriage Assembly. See Figure 5-13. Perform this procedure on both screws of the Chain Support Bracket.

ASSEMBLY/ DISASSEMBLY

Assembly\Disassembly 5-23