NovaJet 500/630/700 Series Service Manual
3.Slide the Carriage Assembly (if installed) to the far left side of the Slide Shaft. While ensuring a 5” (125mm) overhang on the right side, position the Trailing Cable over the Stabilizer Bracket and slowly lower it onto the bracket. Ensure that the Trailing Cable goes on straight and that there are no buckles in the cable. Firmly press the Trailing Cable Assembly onto the tape to secure it into position.
4.Connect the right end to the MPCB at the J6 location.
5.Tape the ferrite to the Trailing Cable approximately 1/4” (6mm) from the left side of the side plate.
6.If the Carriage Assembly is not installed, perform steps 5 through 18 of the Install the Carriage Assembly, Carriage Belt, and the Frame Tensioner procedures.
7.If the Carriage Assembly is installed, insert the Trailing Cable Assembly into the Strain Relief Assembly. Insert the Strain Relief (with Trailing Cable) onto the Carriage Assembly by sliding it onto the Strain Relief Support until it snaps firmly into place.
Remove the Stabilizer Bracket and Encoder Strip
1.Perform steps 1 through 13 of the Remove the Left, Top, and Right Covers procedures to remove the Left, Top and Right Covers.
2.Perform steps 2 through 6 of the Remove the Ink Delivery System procedures to remove the Ink Delivery System.
3.Perform the Remove the Carriage Assembly, Carriage Belt, and the Frame Tensioner procedures to remove the Carriage Assembly from the Slide Shaft.
4.Perform steps 3 and 4 of the Remove the Trailing Cable Assembly procedures to remove the Trailing Cable Assembly.
5.Remove the Support Bracket by slightly tilting the top of the Support Bracket towards the front of the printer and lifting it straight up. See Figure
